Operation Manual

6
PROGRAMMING
SETTING PROGRAM 1
The program number can only be set/changed in the
Set Start Times
position.
STEP 1. Set Start Times
All valves will activate in sequential order for each start time. Turn the
dial to Set Start Times and ensure that “Prog 1” is flashing.
THE DISPLAY WILL SHOW:
Press & “Start 1” willl flash.
Press
& the “hour” will flash.
Use or to adjust.
NOTE: AM / PM is set correctly.
Press & the “minutes” will flash. Use or to adjust, if
required. Each program has up to four start times and should you
require a second start time,
Press
twice & “Start 1” will flash.
Advance to start 2 by pressing .
THE DISPLAY WILL SHOW:
Press and proceed as per setting Start 1.
TIP: To turn an active start time off, turn the dial to the Set Start times
position, select the start number required using the button and then
press until the “hour” is flashing. Use or until “OFF” is shown.
TIP: “OFF” position is between 12 and 1pm.