Manual

Applications Information (Continued)

Be especially careful with the layout of inductors. Mutual

inductance can change the characteristics of the circuit in

which they are used. Inductors should not be placed side by

side, even with just a small part of their bodies beside each

other.

The analog input should be isolated from noisy signal traces

to avoid coupling of spurious signals into the input. Any

external component (e.g., a filter capacitor) connected be-

tween the converter’s input pins and ground or to the refer-

ence input pin and ground should be connected to a very

clean point in the ground plane.

Figure 6 gives an example of a suitable layout. All analog

circuitry (input amplifiers, filters, reference components, etc.)

should be placed in the analog area of the board. All digital

circuitry and I/O lines should be placed in the digital area of

the board. The ADC11DL066 should be between these two

areas. Furthermore, all components in the reference circuitry

and the input signal chain that are connected to ground

should be connected together with short traces and enter the

ground plane at a single, quiet point. All ground connections

should have a low inductance path to ground.

6.0 DYNAMIC PERFORMANCE

To achieve the best dynamic performance, the clock source

driving the CLK input must be free of jitter. Isolate the ADC

clock from any digital circuitry with buffers, as with the clock

tree shown in Figure 7. The gates used in the clock tree must

be capable of operating at frequencies much higher than

those used if added jitter is to be prevented.

Best performance will be obtained with a differential input

drive, compared with a single-ended drive, as discussed in

Sections 1.3.1 and 1.3.2.

As mentioned in Section 5.0, it is good practice to keep the

ADC clock line as short as possible and to keep it well away

from any other signals. Other signals can introduce jitter into

the clock signal, which can lead to reduced SNR perfor-

mance, and the clock can introduce noise into other lines.

Even lines with 90˚ crossings have capacitive coupling, so

try to avoid even these 90˚ crossings of the clock line.

20077316

FIGURE 6. Example of a Suitable Layout

ADC11DL066