User Manual

Connection Diagrams
TL/H/11876–15
Top View
TL/H/11876–29
Top View
Pin Descriptions
AV
CC
These are the two positive analog supply
inputs. They should always be connected
to the same voltage source, but are
brought out separately to allow for sepa-
rate bypass capacitors. Each supply pin
should be bypassed to AGND with a
0.1 mF ceramic capacitor in parallel with a
10 mF tantalum capacitor.
DV
CC
This is the positive digital supply input. It
should always be connected to the same
voltage as the analog supply, AV
CC
.It
should be bypassed to DGND2 with a
0.1 mF ceramic capacitor in parallel with a
10 mF tantalum capacitor.
AGND, These are the power supply ground pins.
DGND1, There are separate analog and digital
DGND2 ground pins for separate bypassing of the
analog and digital supplies. The ground
pins should be connected to a stable,
noise-free system ground. All of the
ground pins should be returned to the
same potential. AGND is the analog
ground for the converter. DGND1 is the
ground pin for the digital control lines.
DGND2 is the ground return for the output
databus. See Section 6.0 LAYOUT AND
GROUNDING for more information.
DB0– DB11 These are the TRI-STATE output pins, en-
abled by RD
,CS, and OE.
V
IN1
,V
IN2
These are the analog input pins to the mul-
tiplexer. For accurate conversions, no in-
put pin (even one that is not selected)
should be driven more than 50 mV below
ground or 50 mV above V
CC
.
MUX OUT This is the output of the on-board analog
input multiplexer.
ADC IN This is the direct input to the 12-bit sam-
pling A/D converter. For accurate conver-
sions, this pin should not be driven more
than 50 mV below ground or 50 mV above
V
CC
.
S0 This pin selects the analog input that will
be connected to the ADC12662 during the
conversion. The input is selected based on
the state of S0 when EOC makes its high-
to-low transition. Low selects V
IN1
, high
selects V
IN2
.
MODE This pin should be tied to DGND1.
CS
This is the active low Chip Select control
input. When low, this pin enables the RD
,
S/H
, and OE inputs. This pin can be tied
low.
INT
This is the active low Interrupt output.
When using the Interrupt Interface Mode
(Figure 1), this output goes low when a
conversion has been completed and indi-
cates that the conversion result is avail-
able in the output latches. This output is
always high when RD
is held low (Figure
2).
EOC This is the End-of-Conversion control out-
put. This output is low during a conversion.
RD
This is the active low Read control input.
When RD
is low (and CS is low), the INT
output is reset and (if OE is high) data ap-
pears on the data bus. This pin can be tied
low.
9