Manual

ManualsBrandsRainbow Electronics ManualsAcousticsAPC5800M

INTEGRATED CIRCUITS INC.

http://www.aplusinc.com.tw PAGE / 5 VER1.3

COMPRESS VOICE --- APC5800M MODULE

 Part No. : APC5800M4 & APC5800M2

 Module size : 32.8 x 45.6 mm

 VCC : 4.5V

 I/O : PA0 ~ PA7 + PB0 ~ PB7

 Speaker output : DAC ( 12 bits ) or PWM

 Compress : 6K bps ~ 14.4K bps for VOICE / 10K bps ~ 24K bps for MUSIC

Part no. 6K 7.2K 8.4K 9.6K 10.8K 12K 13.2K 14.4K

APC5800M2 91 min. 75 min. 65 min. 56 min. 50 min. 45 min. 41 min. 37 min.

APC5800M4 182 min. 151 min. 130 min. 113 min. 101 min. 91 min. 82 min. 75 min.

6K bps ~ 14.4 K bps for VOICE compress

Part no. 10K 12K 14K 16K 18K 20K 22K 24K

APC5800M2 54 min. 45 min. 39 min. 34 min. 30 min. 27 min. 24 min. 22 min.

APC5800M4 109 min. 91 min. 78 min. 68 min. 60 min. 54 min. 49 min. 45 min.

10K bps ~ 24K bps for MUSIC compress

Summary of content (5 pages)

PAGE 1
INTEGRATED CIRCUITS INC. COMPRESS VOICE --- APC5800M MODULE Part No. : APC5800M4 & APC5800M2 Module size : 32.8 x 45.6 mm VCC : 4.5V I/O : PA0 ~ PA7 + PB0 ~ PB7 Speaker output : DAC ( 12 bits ) or PWM Compress : 6K bps ~ 14.4K bps for VOICE / 10K bps ~ 24K bps for MUSIC Part no. 6K 7.2K 8.4K 9.6K 10.8K 12K 13.2K 14.4K APC5800M2 91 min. 75 min. 65 min. 56 min. 50 min. 45 min. 41 min. 37 min. APC5800M4 182 min. 151 min. 130 min. 113 min. 101 min. 91 min. 82 min. 75 min. 6K bps ~ 14.
PAGE 2
INTEGRATED CIRCUITS INC. 1 2 VDD4V5 Reset 22 3 4 5 6 7 8 9 10 11 PWM1 PB6 PB4 PB2 PB0 PA6 PA4 PA2 PA0 20 19 18 17 16 15 14 13 12 PB5 PB3 PB1 PA7 PA5 PA3 PA1 21 GND VDD3V PWM2 DAC PS: PIN-19 is DAC output for drive OP-AMP,but Q1,R5& C9 must be delete ADDRESS ARRANGEMENT : 1. RAM 0000-07FF: Internal RAM of 1Kx16 0000-1FFF: External, Non-Bank RAM (Extramcs=1) of 4Kx16 2.
PAGE 3
INTEGRATED CIRCUITS INC. Memory Mapping 3FE0 System Flag. Read only 3FE0 System control 0. Write only Bit 0: = not used 1: = no used 2: = 1 -- error in ADC 0 -- no error in ADC 3: = 1 Timer_A INT flag Timer IRQ Timer_A INT flag 1 1 Timer_A INT 1 0 Fix_Timer INT 0 x no Timer INT 4: = 1 (not used) 5: = 1 (executed flag of Coprocessor) 6: = 1 (coprocessor’s carry) 7: = 1 (tone0 or tone1 enabled) http://www.aplusinc.com.tw PAGE 3 / 5 Bit 0: = must be 0. 0 --PA14 and PA15 are IO pins (default).
PAGE 4
INTEGRATED CIRCUITS INC. 3FE1 System Control 1. Write only 3FE2 System control 2. Write only Bit 0: = 1 -(Timer A clock selects system clock.) Bit 0: = 1-- (Entry to stand-by mode) 0- (Timer A clock selects 32.768k Hz.) (Default) In stand-by mode, CPU is held. The NMI and 1: = not used (must be 0.) IRQ will wake up the CPU.
PAGE 5
INTEGRATED CIRCUITS INC. 3FEE 3FEF low byte data of Timer B. Read and write high byte data of Timer B. Read and write After timer_b is enabled, the timer will start to count down. When timer counts to zero, the timer will count from the initial value and timer_b NMI will happen. The time elapsing = (($3FEF,$3FEE)+1) / (Timer B input clock) 3FF0 3FF1 3FF2 3FF4 3FF5 direction register of Port_a[15..8]. Write only A ‘1’ in this register will set the corresponding pin of port_a to be output.