Owner's manual

GE863-PRO
3
Product Description
80285ST10036a Rev. 1 - 08/08/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 43 of 55
The FCC requires the user to be notified that any changes or modifications made to this device that
are not expressly approved by Telit Communications S.p.A. may void the user’s authority to operate
the equipment.
To meet the FCC’s RF exposure rules and regulations:
• The antenna(s) used for this transmitter must be installed to provide a separation distance of at
least 20 cm from all the persons and must not be co-located or operating in conjunction with any
other antenna or transmitter.
• The antenna(s) used for this module must not exceed 3 dBi for mobile and fixed or mobile
operating configurations.
Manufacturers of mobile, fixed or portable devices incorporating this module are advised to clarify any
regulatory questions and to have their complete product tested and approved for FCC compliance.
Interference statement:
The Telit GE863-PRO
3
module complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
• this device may not cause harmful interference, and
• this device must accept any interference received, including interference that may
cause undesired operation.
For questions regarding your product or this FCC declaration, contact:
Telit wireless solutions Inc.
Americas
3131 RDU Center Drive,
USA – 27560 Morrisville, NC 27560, USA
Phone: [phone]
Fax: + 1 888 846 9774
e-mail: [e-mail]
To identify this product, refer to the Part, Series, or Model number found on the product.