Owner manual

ground’s power supply is low impedance and as short
as possible. Route digital signals far away from sensi-
tive analog and reference inputs.
High-frequency noise in the power supply (V
DD
) could
influence the proper operation of the ADC’s fast com-
parator. Bypass V
DD
to the star ground with a network of
two parallel capacitors, 0.1µF and 4.7µF, located as
close as possible to the MAX1136–MAX1139 power-sup-
ply pin. Minimize capacitor lead length for best supply
noise rejection, and add an attenuation resistor (5Ω) in
series with the power supply, if it is extremely noisy.
Definitions
Integral Nonlinearity
Integral nonlinearity (INL) is the deviation of the values on
an actual transfer function from a straight line. This straight
line can be either a best straight-line fit or a line drawn
between the endpoints of the transfer function, once offset
and gain errors have been nullified. The MAX1136–
MAX1139’s INL is measured using the endpoint.
Differential Nonlinearity
Differential nonlinearity (DNL) is the difference between
an actual step width and the ideal value of 1LSB. A
DNL error specification of less than 1LSB guarantees
no missing codes and a monotonic transfer function.
Aperture Jitter
Aperture jitter (t
AJ
) is the sample-to-sample variation in
the time between the samples.
Aperture Delay
Aperture delay (t
AD
) is the time between the falling
edge of the sampling clock and the instant when an
actual sample is taken.
Signal-to-Noise Ratio
For a waveform perfectly reconstructed from digital sam-
ples, the theoretical maximum SNR is the ratio of the full-
scale analog input (RMS value) to the RMS quantization
error (residual error). The ideal, theoretical minimum ana-
log-to-digital noise is caused by quantization error only
and results directly from the ADC’s resolution (N Bits):
SNR
MAX[dB]
= 6.02
dB
✕ N + 1.76
dB
In reality, there are other noise sources besides quanti-
zation noise: thermal noise, reference noise, clock jitter,
etc. SNR is computed by taking the ratio of the RMS
signal to the RMS noise, which includes all spectral
components minus the fundamental, the first five har-
monics, and the DC offset.
Signal-to-Noise Plus Distortion
Signal-to-noise plus distortion (SINAD) is the ratio of the
fundamental input frequency’s RMS amplitude to RMS
equivalent of all other ADC output signals.
SINAD (dB) = 20
✕ log (SignalRMS/NoiseRMS)
MAX1136–MAX1139
2.7V to 3.6V and 4.5V to 5.5V, Low-Power,
4-/12-Channel, 2-Wire Serial 10-Bit ADCs
______________________________________________________________________________________ 19
011...111
OUTPUT CODE
ZS = AIN-
011...110
000...010
000...001
000...000
111...111
111...110
111...101
100...001
100...000
-FS + LSB
AIN-
INPUT VOLTAGE (LSB)
+FS - 1LSB
1LSB =
V
REF
1024
AIN- ≥
V
REF
2
FS =
V
REF
+ AIN-
2
-FS =
-V
REF
+ AIN-
2
1
2
Figure 13. Bipolar Transfer Function
GND
V
LOGIC
= 3V/5V3V OR 5V
SUPPLIES
DGND3V/5VGND
*OPTIONAL
4.7µF
R* = 5Ω
0.1µF
V
DD
DIGITAL
CIRCUITRY
MAX1136–
MAX1139
Figure 14. Power-Supply Grounding Connection