Owner's manual

MAX679
Regulated 3.3V Charge Pump
2 _______________________________________________________________________________________
ABSOLUTE MAXIMUM RATINGS
ELECTRICAL CHARACTERISTICS
(V
IN
= V
SHDN
= V
FSET
= 2V, C
IN
= 4.7µF, C1 = 0.33µF, C
OUT
= 10µF, T
A
= -40°C to +85°C, unless otherwise noted. Typical values
are at T
A
= +25°C.) (Note 1)
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to
absolute maximum rating conditions for extended periods may affect device reliability.
Note 1: Specifications to -40°C are guaranteed by design, not production tested.
IN, OUT, SHDN, FSET to GND....................................-0.3V to 6V
PGND to GND.....................................................................±0.3V
C1- to GND..................................................-0.3V to (V
IN
+ 0.3V)
C1+ to GND..............................................-0.3V to (V
OUT
+ 0.3V)
OUT Short to GND..............................................................10sec
Continuous Power Dissipation (T
A
= +70°C)
µMAX (derate 4.1mW/°C above +70°C) .......................330mW
Operating Temperature Range ...........................-40°C to +85°C
Storage Temperature Range.............................-65°C to +160°C
Lead Temperature (soldering, 10sec).............................+300°C
FSET = GND
FSET
,
SHDN = GND or V
IN
V
IN
= 2V, I
OUT
= 10mA
V
IN
= 3.6V
V
IN
= 1.8V
V
IN
= 1.8V, V
OUT
> 3.17V
V
IN
= 2.5V, FSET = IN or GND
V
OUT
= 3.6V, SHDN = GND
OUT = GND, V
IN
= 3.3V
V
IN
= 3.3V
FSET = IN
CONDITIONS
%80Efficiency
mA100 200Output Short-Circuit Current
kHz
700 1000 1300
V0.8 1.6
V1.8 3.6Input Voltage
Input Undervoltage Lockout Voltage
260 330 450
Switching Frequency
µA0.1 1
FSET, SHDN Input Leakage Current
V
0.7 x 0.5 x
V
IN
V
IN
FSET, SHDN Input Voltage High
V
0.5 x 0.3 x
V
IN
V
IN
FSET, SHDN Input Voltage Low
mA20Output Current
µA50 80No-Load Supply Current
µA15 25Leakage Current into OUT in Shutdown
µA1 5Supply Current in Shutdown
UNITSMIN TYP MAXPARAMETER
2V < V
IN
< 3.3V,
0mA < I
OUT
< 20mA
3.15 3.45
Output Voltage
T
A
= 0°C to +85°C
T
A
= -40°C to +85°C
V
3.17 3.3 3.43