UC864-E/G Product Description UC864-E/G 80281ST10034a Rev.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 APPLICABILITY TABLE PRODUCT PART NUMBER UC864-E 4990250031 UC864-G 4990250030 Reproduction forbidden without Telit Communications S.p.A.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 Contents 1 Overview ........................................................................................................................... 6 2 General Product Description........................................................................................... 8 2.1 Dimensions ...........................................................................................................................8 2.2 Weight .....................
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2.12.16 2.13 RF Transmission Monitor............................................................................................................ 20 Logic level specifications ..................................................................................................20 2.13.1 Reset signal .................................................................................................................................... 20 2.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 DISCLAIMER The information contained in this document is the proprietary information of Telit Communications S.p.A. and its affiliates (“TELIT”). The contents are confidential and any disclosure to persons other than the officers, employees, agents or subcontractors of the owner or licensee of this document, without the prior written consent of Telit, is strictly prohibited.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 1 Overview The Telit UC864-E/G module are small, lightweight, low power consumption and RoHS compliant devices that allow digital communication services wherever a WCDMA/HSDPA (850 ,1900 and 2100 MHz for UC864-G and only 2100 MHz for UC864-E), GSM 850, 900, DCS 1800 or PCS 1900 network is present with additional options like an integrated GPS receiver (in UC864-G only).
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 • • • • • • - Fixed baud rate up to 230 Kbps SIM card interface, 1.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2 General Product Description 2.1 Dimensions Dimensions UC864-E UC864-G Length(mm) 36.2 45 Width(mm) 30 30 Thickness(mm) 4.8 4.8 Reproduction forbidden without Telit Communications S.p.A.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 UC864-E drawing UC864-G drawing Reproduction forbidden without Telit Communications S.p.A.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2.2 Weight Weight 2.3 UC684-E 10 gr. UC864-G 12.8 gr. Environmental requirements The Telit UC864-E/G module is compliant with the applicable 3gpp reference documentation TS 25.101 Release 2004-03. 2.3.1 Temperature range UC864-E/G -20 ~ +55°C Operating temperature -30 ~ +80°C Temperature in not functional conditions Note The module is functional in all the temperature range, and it fully meets the ETSI specifications.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2.3.3 RoHS compliance As a part of Telit corporate policy regarding environmental protection, the UC864-E/G comply with the RoHS (Restriction of Hazardous Substances) directive of the European Union (EU Directive 2002/95/EG). 2.4 Operating Frequency The operating frequencies in WCDMA/HSDPA, GSM850, EGSM900, DCS, PCS modes are conform to the WCDMA and 3gpp specifications. Mode Freq. TX (MHz) WCDMA-850 826.4-846.6 WCDMA-1900 1852.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 DCS1800/PCS1900(GSM/GPRS mode) The Telit UC864-E/G transceiver modules in DCS1800/PCS1900 operating mode are class 1 in accordance with the specifications which determine the nominal 1W peak RF power (+30dBm) on 50 Ohm. DCS1800/PCS1900(EGPRS mode) The Telit UC864-E/G transceiver modules in DCS1800/PCS1900 operating mode are class E2 in accordance with the specifications which determine the nominal 0.4W peak RF power (+26dBm) on 50 Ohm. 2.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2.7.2 GPS Antenna (only for UC864-G) The active GPS antenna should fulfill the following requirements: Frequency range Bandwidth 1575.42 MHz(GPS L1 band) +/- 2 MHz The supply voltage to the active GPS antenna is provided by the UC864-G. For further information please refer to the UC864 Hardware User Guide. 2.7.3 UC864-E/G Antenna connectors 2.7.3.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 • Supports 12-Channel GPS L1 1575.42 MHz • Accuracy < 3m (CEP68 : 68% Circular Error Probable ) • GPS NMEA 0183 output format • Date WGS-84 • Dedicated GPS AT commands • Low power consumption 2.8.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2.8.4 GPS NMEA The GPS data stream (NMEA 0183 format) is also available on the pin-out in USB data format. 2.8.5 NMEA sentences The following GPS sentences are available: GGA - Global positioning system fix data (provides 3D location and accuracy data) VTG – Course over ground and ground speed GSA - GPS DOP and active satellites RMC - Recommended Minimum Specific GPS Data GLL - Geographic Latitude and Longitude 2.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2.10 WCDMA/GSM Power consumption The typical current consumption of the Telit UC864-E/G is: Power off current (typical) < 26 µA; Stand–by current (WCDMA Idle) < 23.2mA (<5.3mA using command AT+CFUN=5) Stand–by current (GSM Idle) < 15.0mA (<3.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2.12 User Interface The user interface is managed by AT commands specified on the ITU-T V.250, 3gpp 27.007 and 27.005 specifications. 2.12.1 Speech Coding The UC864-E/G voice codec supports the following rates: • • 2.12.2 WCDMA o Adaptive Multi Rate GSM o Half Rate o Full rate o Enhanced Full Rate o Adaptive Multi Rate SIM Reader The UC864-E/G supports R5 and R99 3gpp TS 31.114 - USIM 1.8V and 3V ONLY with an external SIM connector.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2.12.5 Data/fax Transmission The Telit UC864-E/G supports: • • • • 2.12.6 WCDMA/HSDPA category 8, MS Class A (Simultaneous Voice and Data) EGPRS/GPRS CLASS 12, MS Class B CSD up to 14.4 Kbps Fax service, Class 1 Group 3. Local security management The local security management can be done with the lock of Universal Subscriber Identity module (USIM), and security code request at power–up. 2.12.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2.12.12 Automatic answer (Voice, Data or FAX) After a specified number of rings, the module will automatically answer with a beep. The user can set the number of rings by means of the command ATS0=. 2.12.13 Supplementary services (SS) The following supplementary services are supported: • • • • • • • • • 2.12.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2.12.16 RF Transmission Monitor As alternate function of the GPIO5, the UC864-E/G provides the RF transmission monitor. When the alternate function is activated, the pin of GPIO5 changes to HIGH every time the module transmits an RF signal and remains HIGH for the duration of the transmission sequence 2.13 Logic level specifications Where not specifically stated, all the interface circuits work at 2.6V CMOS logic levels.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2.14 Audio levels specifications The audio of the UC864-E/G is organized into two main paths: • • internal path (called also MT) external path (called also HF) These two paths are meant respectively for handset and headset/hands-free use.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2.15 Converters 2.15.1 ADC Converter The on board ADCs are 8-bit converter. They are able to read a voltage level in the range of 0 - 2 volts applied on the ADC pin input, store and convert it into 8 bit word. Input Voltage range AD conversion Resolution Sampling rate 2.15.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2.16 Mounting the UC864-E/G on your board 2.16.1 UC864-G The position of the Molex board to board connector and the pin 1 are shown in the following picture. NOTE: metal tabs present on UC864-G should be connected to GND Reproduction forbidden without Telit Communications S.p.A.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2.16.2 UC864-E NOTE: metal tabs present on UC864-E should be connected to GND Reproduction forbidden without Telit Communications S.p.A.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 2.17 Packing system The Telit UC864-E is packaged on trays of 20 pieces each. Reproduction forbidden without Telit Communications S.p.A.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 3 Evaluation Kit In order to assist you in the development of your Telit UC864-E/G module based application, Telit can supply the EVK2 Evaluation Kit with appropriate power supply, SIM card housing, RS 232 serial port level translator, direct UART connection, Handset, Headset and Hands-free (car kit) audio, antenna. The EVK2 provides a fully functional solution for a complete data/phone application.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 4 Software Features 4.1 4.1.1 Enhanced Easy GPRS Extension Overview The Easy WCDMA/GPRS feature allows the Telit UC864-E/G user to contact a device in internet and establish with it a raw data flow over the WCDMA/GPRS and Internet networks.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 • A new internal firewall has been implemented in order to guarantee a certain level of security on internet applications. 4.1.2 Easy GPRS definition The Easy GPRS feature provides a way to replace the need of an Internet TCP/IP stack at the terminal equipment side.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 5 AT Commands The Telit UC864-E/G module can be driven via the serial interface using the standard AT commands1. The Telit UC864-E/G module is compliant with: 1. Hayes standard AT command set, in order to maintain the compatibility with existing SW programs. 2. 3gpp TS 27.007 specific AT command and WCDMA/GPRS specific commands. 3. 3gpp TS 27.005 specific AT commands for SMS (Short Message Service) and CBS (Cell Broadcast Service) 4.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 6 Conformity Assessment Issues The Telit UC864-E is assessed to be conform to the R&TTE Directive in the WCDMA2100/GSM900/GSM1800. If the antenna connected to the module is conforming to the requirements specified under this document, it requires no further evaluation under Article 3.2 of the R&TTE Directive and do not require further involvement of a R&TTE Directive Notified Body for the final product.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 • The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all the persons and must not be co-located or operating in conjunction with any other antenna or transmitter. • The antenna(s) used for this module must not exceed 3 dBi for mobile and fixed or mobile operating configurations.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 7 SAFETY RECOMMENDATIONS READ CAREFULLY Be sure the use of this product is allowed in the country and in the environment required.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 7.1 Contact Information, Support Our aim is to make this guide as helpful as possible. Keep us informed of your comments and suggestions for improvements. For general contact, technical support, report documentation errors and to order manuals, contact your regional Technical Support Center at: • • • TS-EMEA@telit.com, TS-AMERICAS@telit.com, TS-APAC@telit.com Or use: http://www.telit.com/en/products/technical-support-center/contact.
UC864-E/G Product Description 80281ST10034a Rev.
UC864-E/G Product Description 80281ST10034a Rev.
UC864-E/G Product Description 80281ST10034a Rev. 1 - 08/08/2008 8 Document Change Log Revision Date Changes [dd/mm/yyyy] 0 Draft 1 07/11/2007 Initial issue 08/08/2008 general revision of the document Reproduction forbidden without Telit Communications S.p.A.