Instruction Manual

W90P710CD/W90P710CDG
- 414 -
31 30 29 28 27 26 25 24
RESERVED PUPEN5[14:8]
23 22 21 20 19 18 17 16
PUPEN5[7:0]
15 14 13 12 11 10 9 8
RESERVED OMDEN5[14:8]
7 6 5 4 3 2 1 0
OMDEN5[7:0]
BITS DESCRIPTION
[31] RESERVED
-
[30:16]
PUPEN5
GPIO19 ~ GPIO5 port pin internal pull-up resister enable
1 = enable
0 = disable
[15] RESERVED
[14:0]
OUTEN5
GPIO19 ~ GPIO5 output mode enable
1 = output mode
0 = input mode
NOTE: Output mode enable bits are valid only when bit
PT5CFG9-0 is configured as general purpose I/O mode.
Each port pin can be enabled individually by setting the
corresponding control bit.
GPIO Port5 Data Output Register (GPIO_DATAOUT5)
REGISTER ADDRESS R/W DESCRIPTION RESET VALUE
GPIO_DATAOUT5 0xFFF8_3058 R/W GPIO port5 data output register 0x0000_0000
31 30 29 28 27 26 25 24
RESERVED
23 22 21 20 19 18 17 16
RESERVED
15 14 13 12 11 10 9 8
RESERVED DATAOUT5[14:8]
7 6 5 4 3 2 1 0
DATAOUT5[7:0]