Instruction Manual

W90P710CD/W90P710CDG
- 418 -
31 30 29 28 27 26 25 24
RESERVED PUPEN6[11:8]
23 22 21 20 19 18 17 16
PUPEN6[7:0]
15 14 13 12 11 10 9 8
RESERVED OMDEN6[11:8]
7 6 5 4 3 2 1 0
OMDEN6[7:0]
BITS DESCRIPTION
[31:27] RESERVED
-
[26:16]
PUPEN6
GPIO30 ~GPIO41 port pin internal pull-up resister enable
1 = enable
0 = disable
[15:13] RESERVED
[12:0]
OMDEN6
GPIO41 ~ GPIO30 output mode enable
1 = output mode
0 = input mode
NOTE: Output mode enable bits are valid only when bit
PT6CFG11-0 is configured as general purpose I/O mode.
Each port pin can be enabled individually by setting the
corresponding control bit.
GPIO Port6 Data Output Register (GPIO_DATAOUT6)
REGISTER ADDRESS R/W DESCRIPTION RESET VALUE
GPIO_DATAOUT6 0xFFF8_3068 R/W GPIO port6 data output register 0x0000_0000
31 30 29 28 27 26 25 24
RESERVED
23 22 21 20 19 18 17 16
RESERVED
15 14 13 12 11 10 9 8
RESERVED DATAOUT6[11:8]
7 6 5 4 3 2 1 0
DATAOUT6[7:0]