MODEL NO.: QPCF Color Quad Processor Operating Instructions CAUTION This is an intelligent device. Please connect the video cable on channel one and then power on. The device will detect system automatically for PAL or NTSC. QPCF-V0.
PRECAUTIONS Safety The unit operates on DC12V, 500mA To reduce risk of fire or electric shock, do not expose this appliance to rain or moisture. Do not attempt to service this unit yourself as opening or removing the cover, it may expose you to risk of electric shock. Refer servicing to qualified service personnel. Notice The information in this operating instruction was current when published. The manufacturer reserves the right to revise and improve its products.
Table of contents 1. INDEX TO PARTS AND CONTROLS…………………………………………………………………..……….…1 1.1 FRONT VIEW 1.2 REAR VIEW 2. SET UP MENUS…………………………………………………………………………………………………...……2,3 2.1 MAIN LIST 2.2 ALARM DURATION 2.3 BAUD RATE 2.4 DWELL TIME 2.5 INT AUDIBLE ALARM 2.6 EXT AUDIBLE ALARM 2.7 SET TIME 2.8 DWELL SET UP 2.9 ALARM POLARITY 2.10 CAMERA TITLE SET UP 2.11 EVENT LIST 2.12 VIDEO SET 2.13 SYSTEM RESET 3. ADDITIONAL OPERATIONS………………………………………………………………….………….………3,4 3.1 FULL SCREEN 3.2 QUAD 3.3 AUTO 3.4 FREEZE 3.
1. INDEX TO PARTS AND CONTROLS 1.1 FRONT VIEW R 1. MENU (exit) - It allows access to the system setup menus and exit the current status. 2. ( ▲ ) - Displays the CH1 camera in the full screen format. It is also used to select the function under operating menu. 3. ( ▼ ) - Displays the CH2 camera in the full screen format. It is also used to select the function under operating menu. 4. ( ◄ ) - Displays the CH3 camera in the full screen format.
2. SET UP MENUS A convenient system of on-screen menus allows you to set up key features such as sequencer dwell time, camera titles, camera color and time & date. The following paragraphs take you through the menu system step-by-step, describing each menu’s purpose and options. After connecting all cameras and monitor, please make sure you have plugged the power supply to quad too. Then you’ve already turned on the Digital Color Quad Processor.
2.9 ALARM POLARITY: three options HIGH, LOW or OFF for polarity set up 1. Use ◄► to select polarity. 2. Press ▲▼ to select channel 4. Press MENU to exit 2.10 CAMERA TITLE SETUP: to set up each camera’s title 1. Use ◄► to select the position 2. Press ▲▼ to select channel 3. Use “+”, “-“ to select the words 4. Press MENU to exit 2.11 EVENT LIST: to check the record of video loss or alarm status 1. Press ENTER to clear records 2. Press MENU to exit 2.
3.7 ALARM CONNECTOR PIN ASSIGNMENTS 3.7.1 25PIN COM PORT: 3.7.2 9PIN COM PORT: 3.8 REMOTE CONTROL OPERATION If you would like to connect this device to computer, please find following ASCII codes for reference.
4. ADDITIONAL INFORMATIONS 4.1 TROUBLE SHOOTING PROBLEM SUGGESTED ACTION Bad picture quality after power Please connect the video cable on channel one before power on. The device will detect system automatically for PAL or NTSC. on 1. Please check if the power supply is connected. 2. Please check if the wiring between monitor and quad is correct. No Video Video Loss Ex. CH1 video loss at 04:08 LOSS 04:08 CH2 CH3 CH4 Please check CH1 camera is connected properly.