Installation Manual Farmhouse Sink RX-SS01, RX-SS02, RX-SS03, RX-SS04, RX-SS05, RX-SS06, RX-SS07, RX-SS08, RX-SS09, RX-SS10, RX-SS11, RX-SS12, RX-SS13
INDEX 1. cUPC certificate . . . . . . . . . . . . . . . . . . . . . . . . . P01 2. Installation Guide . . . . . . . . . . . . . . . . . . . P02-P04 3. How to maintenance . . . . . . . . . . . . . . . . P05-P06 Due to the weight and sharp edges of the sink, exercise caution when handling, moving or lifting the box or the sink. Use safety gloves and protective gear for eyes and ears. Get assistance when lifting or mounting the sink at any time during the installation procedure.
Installation Guide Make a proper frame under to support the farmhouse sink. Measure the height of apron sink, cut cabinet front cutout and countertop cutout accordingly Make sure there is a proper spacing for sink before gluing and inserting screws into the wood and cabinet. Cut two support framings to extend along the inner walls of the cabinet on each side of the base.
Installation Guide 5 Put the sink into the cabinet. Check if the sink is resting on the supports. 6 7 Apply the silicone sealant to the top of each support. 8 Remove the sink. Place the sink onto the support and adjust it to be in proper position. Sink should be positioned at least 4’’ between the back of the cabinet to allow faucet installation.
Installation Guide 9 11 Then cover the countertop on the sink. 10 Install the secure clips to the countertop, make sure each clip engages with the rim of the sink (minimum 4 clips in back, 2 clips per side). Tighten each clips evenly. Complete countertop installation and wipe away any excess caulk from the sink rim. • Connect drain to sink. Connect trap to drain. Connect water supply connections to faucet according to manufacturer’s instructions. • Run water into sink and check for leaks.
MAINTENANCE INSTRUCTIONS 1.Why is there rust in my new kitchen sink? Reasons: 1.1 The rust may be caused by the welding cement, or oil residue on the sink which when not cleaned on time can lead the sink to rust. 1.2 Chemical cleaning agent, paint, sauces or cooking oil left in the kitchen sink after a certain period. these will create molds and the molds would stick on the surface. Prevention and Treatments: 1.1 Install the sink after everything else is done, and clean your sink right after installation.
CAUTION DO 1. Clean Daily. Use a soft towel to wipe the sink with warm water. Mixing in some washer-fluid is advisable. Remember to wipe it dry. 2. Remember to rinse the sink after using any cleaning agent and wipe dry. lf any mineral deposits built up on the sink, clean up it as soon as possible. 3. Properly remove the rust, molds or scratches with a scouring pad. Rubbing the sink in the direction of the grain. 4. Rub it lightly with a soft towel in the direction of grain lines. 5.
