Installation Guide

DO
1. Clean Daily. Use a soft towel to wipe the sink with warm water. Mixing in some washer-fluid is
advisable. Remember to wipe it dry.
2. Remember to rinse the sink after using any cleaning agent and wipe dry. lf any mineral deposits
built up on the sink, clean up it as soon as possible.
3. Properly remove the rust, molds or scratches with a scouring pad. Rubbing the sink in the direction
of the grain.
4. Rub it lightly with a soft towel in the direction of grain lines.
5. Keep the sink dry after you use it. Because any standing water can cause a buildup of mineral
deposit, which will become hard water stains.
DO NOT
1. Leave water spots, utensils or steel coo-ware in the sink for a long time, which would become
rust spots in your sink surface.
2. Leave cleaning agents or bleach sitting in your sink for a long period of time which may cause
the sink to discolor or damage the surface.
3. Use a steel wool or scouring pad rubbing against the direction of the grain.
4. Leave rubber mats, cleaning pads or sponges in the sink for a long time as this may ruin the
finish of your sink.
5. Use the inside of the sink as cutting surface.
How to use scouring pad correctly?
1.Get a dry and clean non-scratch scrub pad
2.Scrub the rust off according to the direction of the grain.
CAUTION