Installation Guide

3 Holes Bathroom Sink Faucet
Right of product modification such as dimension without notice is reserved.
1
Align the tee as 'Cold
left, Hot right' and
tighten the retaining
2 nut with hands.
2 3 4 5 6
Install the faucet and
O-ring into the sink
as shown.
Install the washer,
fixing nut and tee
interface.
Insert the handle into
holes as 'Hot left,
Cold right'.
Install O-rings,
washers, mounts and
screws as shown.
Install the hot and cold water hoses and
tighten. Tighten the screws with a
screwdriver them with a wrench.
Tighten the screws
with a screwdriver.
Cross-connect the tee port and the water inlet
of the two handles.
Check the installation result:
1. Make sure all interfaces are tightened.
2. Open the drainage system and the main
Water supply, make sure there are no leaks.
Faucet maintenance:
If there are stains, please wash with neutral
soapy water.
Plate the surface, then wipe the surface with
a damp towel.
7
8
9