Installation Guide

Cold Water
Hot Water
Pipe Connection
1.Please drill the holes on the wall for the main body embedded part, hot
and cold water inlet pipes according to the basic product dimension drawing
as below.
2.Please make hot and cold water inlet pipe, the mixed water outlet pipe
connect with control valve, and tighted with the wrench.
Water Testing And Sealing Testing
1.After the pipeline connection is completed, unscrew the stop valve, open the
pipeline switch to flush the impurities and sludge to avoid blockage and affect
the water flow function;
2.Close the switch, re-tighten the stop valve and open the switch again to make
the pipeline is under pressure. Check the pressure resistance and sealing
performance of the valve and pipeline to ensure that there is no leakage in the
pipeline.
Model: 96207-10
Installation Instruction 2/3
Handheld Shower
Bathtub Spout
170mm
6.7inch
130mm
5.12inch
145mm
5.7inch
Hot Water
Cold Water
Mixer Water
Mixer Water
Tile surface
Wall
Max.80mm
3.15inch
Min.60mm
2.36inch
2.The depth of the embedded box is 2.36” - 3.15”
It's better to drill the depth of 2.36''for blank wall
1.The size of the embedded box that needs
to be drilled is 5.7” *6.7”
17