Instruction Manual

- 28 -
Problem Possible Cause Possible Solution
Hub cannot connect
Plan not executed on time
Not using 2.4GHZ WIFI.
Incorrect WIFI password.
Hub not in pairing state.
Conrm 2.4GHZ WIFI connection.
Conrm that the WIFI password has been
entered correctly.
Press and hold the middle button and
inse it into the socket again without
releasing the button, do not release the
button during this time. After a few
seconds the indicator light will come on
for a while and then sta ashing rapidly.
This means that pairing has been entered.
Inlet impurities need to be cleared
regularly so that they do not clog up and
inteere with the irrigation programme.
Check that the rainfall delay parameter
is set.
Replace fresh batteries.
Check that the irrigation duration/period
is not set with parameters.(Note 12H/24H)
Impurities in water inlet lter.
Rainfall delay parameters are set.
In a low power state, the timer
goes into a low power protection
state and does not execute the
schedule.
irrigation duration/period is not
set with parameters.
If your Rainpoint product does not operate properly after ting the troubleshooting steps, please contact us
by phone or email : [phone] (US Free Hotline)
[phone] (UK Free Hotline)
se[e-mail]
ENENENEN