User manual

Raisecom Technology Co., Ltd
11
6.2.2. Connect the fast Ethernet port
Connect one end of the Cat. 5 UTP cable with Ethernet router/switch and one end of the
cable with the fast Ethernet port of RC953-8FE16E1. The LNK/ACT indicator will be ON
after correct connection.
6.2.3. Connect the SNMP network management port
Connect one end of the Cat. 5 UTP cable with management PC and one end of the cable
with the fast Ethernet port of RC953-8FE16E1. The LNK/ACT indicator will be ON after
correct connection.
6.2.4. Connect the CONSOLE port
● Connect the RJ-45 connector of CONSOLE cable with the CONSOLE port on the
front panel.
● Connect the DB9 connector of CONSOLE cable with the PC serial port.
● Start the HyperTerminal program and configure the COM port properties as follows:
● Configure RC953-8FE16E1 according to software configuration guide
6.2.5. Power on
If power supply is DC –48V, first connect middle end to PGND. Turn off Power Supply,