User's Manual
Table Of Contents
- FCC Compliance Statements
- IC Compliance Statements
- Copyright Statement
- Preface
- 1 Introduction to BreadCrumbs
- 2 Description of a BreadCrumb LX/LX3
- 3 Using BC|Commander
- 4 Deploying the BreadCrumb Wireless Network
- 5 BreadCrumb LX/LX3 Firmware Upgrade
- 6 Troubleshooting
- Appendix A: Error and Warning Codes
- Appendix B: Using Pole Mount Bracket
Rajant Corporation BreadCrumb
®
LX/LX3 User Guide
03-100101-001 Version: 3.00
2.3 Antenna Connectors
The BreadCrumb LX provides two Type N female antenna connectors. The connector located on the
front side of the enclosure (see F in Figure 3) interfaces to the 2.4 GHz antenna. The connector
located on the the back side of the enclosure (see B in Figure 4) interfaces to the 900 MHz, 2.4 GHz,
4.9 GHz or 5 GHz antenna depending on the BreadCrumb LX model.
9
A: ½” Closure Plug (Not Utilized). (LX)
Type N RF Connector for the 2.4 GHz, 4.9 GHz or 5 GHz Antenna (Not Shown). (LX3)
B: Type N RF Connector for the 900 MHz, 2.4 GHz, 4.9 GHz or 5 GHz Antenna. (LX)
Type N RF Connector for the 900 MHz or 5GHz Antenna (LX3)
Figure 4: BreadCrumb LX/LX3 Enclosure Features (Bottom-Rear Side).