User's Manual

Table Of Contents

BreadCrumb

LX/LX3 User Guide Rajant Corporation

Version: 2.91 03-100101-001

Table 7: Status LED Color Codes.

Color Status

Solid Red Booting

Blinking Red

Error

Solid Blue Ready, but no peers

Solid Green At least one 24 Mbps or higher peer

Blinking Green At least one peer

Blinking Yellow

(at a constant rate)

Progress

Blinking Yellow

(with short and long pauses between blinks)

Warning

All Status LED colors scrolling in succession Success/Completion

1.3.6 Zeroize Keys and Restore Factory Defaults / LED Configuration

Switch

The Zeroize Keys and Restore Factory Defaults / LED Configuration Switch (see Figure 3) has two

modes of operation. The modes are set by the length of time the switch is asserted. The modes are:

• Zeroize Keys and Restore Factory Defaults

• LED Configuration

1.3.6.1 Zeroize Keys and Restore Factory Defaults

This mode is is used to erase the security protocol keys of a BreadCrumb LX/LX3 and to restore its

software configuration to the factory default state. To operate this switch follow these procedures:

• Ensure that the BreadCrumb is powered on, has fully booted-up and its Status LED (see

Figure 3) color is green or blue (see Table 7).

• Press the switch and hold the switch for approximately 10 seconds until the Status LED

changes to the error indicator of blinking red. See code 32 in Appendix A for a description

of the blinking red color sequence.

• Release the switch. The BreadCrumb will then reboot using the factory default configuration.

1 For a list of error and warning codes refer to Appendix A at the end of this document.