User's Manual
Table Of Contents
- 1.0 PREFACE
- 2.0 INTRODUCTION
- 3.0 USING BCADMIN™
- _
- 3.1 SCREEN LAYOUT
- 3.2 ANATOMY OF A CONNECTION LINE
- 3.3 CONFIGURING THE BREADCRUMB
- 3.4 RADIO SETTINGS
- 3.5 REACHBACK SETTINGS
- 3.6 FORWARDING SETTINGS
- 3.7 SECURITY
- 3.8 BCADMIN PREFERENCES
- 3.9 MAPPING WITH FUGAWI TRACKER
- 4.0 DEPLOYING THE BREADCRUMB WIRELESS LAN
- 6.0 Troubleshooting
ME BreadCrumb User Guide Rajant Corporation
The following figure illustrates an asymmetric link:
Figure 6. Assymetric Links
3.2.2 INFO AREA
The Info Area shows detailed information specific to the currently selected BreadCrumb device, if any. Select a
BreadCrumb device in the Topology Area by single-clicking it with your mouse. The selected BreadCrumb
device will be highlighted with a dashed border.
The top portion of the Info Area shows a summary of the selected BreadCrumb device’s configuration as pictured
below:
Figure 7. BreadCrumb Summary Panel
In this example, you can see that the selected BreadCrumb device is running version 9.83 of the BreadCrumb
firmware, and has been running for a almost 48 seconds. It has two radios, on channels 1 and 11
which both are
participating in the mesh and serving as access point. You can also see the IPv4 address assigned to radio card
wlan0 is 10.29.210.1 and to radio card wlan1 is 10.29.209.1.
- 17 -