User's Manual
Table Of Contents
- 1.0 PREFACE
- 2.0 INTRODUCTION
- 3.0 USING BCADMIN™
- _
- 3.1 SCREEN LAYOUT
- 3.2 ANATOMY OF A CONNECTION LINE
- 3.3 CONFIGURING THE BREADCRUMB
- 3.4 RADIO SETTINGS
- 3.5 REACHBACK SETTINGS
- 3.6 FORWARDING SETTINGS
- 3.7 SECURITY
- 3.8 BCADMIN PREFERENCES
- 3.9 MAPPING WITH FUGAWI TRACKER
- 4.0 DEPLOYING THE BREADCRUMB WIRELESS LAN
- 6.0 Troubleshooting
Rajant Corporation ME BreadCrumb User Guide
- 50 -
6.1.4 Hardware Reset
1. Turn off the BreadCrumb.
2. Turn the BreadCrumb back on. Wait a minimum of 3 seconds before proceeding.
3. Press and release the black status button to turn on the LED.
4. Press both the black SW2 status button on the left side panel and red zeroize/execute button on the right side
panel at the same time. Continue pressing both of these buttons for approximately 30 seconds.
5. The user will see LEDs cycling through all seven (7) colors. The user can release these buttons after one (1)
complete cycle. When the LED finishes cycling through all seven (7) of its colors, it means that the
zeroizing/factory reset is complete.
Note: If there is no cycling of the colors, it means that a problem exists and that the unit should be returned to
Rajant for repair.
6. After the zeroize/factory reset, the unit will boot up automatically