User's Manual

ManualsBrandsRajant ManualsElectronicsMini PCI Radio Module, 1x1,IEEE 802.11 b/g /n,902 MHz

Vizmonet Pte Ltd

www.vizmonet.com

RJ-1302 USER MANUAL

MODEL RJ-1302

BRAND VIZMONET

FCCID VJA-RJ1302

ICID 7382A-RJ1302

RJ-1302 is an IEEE 802.11b/g/n 902 MHz ~ 928 MHz Radio platform engineered for carrier class long range high

data capacity applications. With superior TX power efficient RF design, the product supports high TX Power

offering best-in class EVM performance at higher modulation schemes. This facilitates to achieve long range

without compromising on data throughput. With well-engineered RX Design, RJ-1302 offers ultra-low receive

sensitivity to achieve long range.

This module shall be integrated into OEM Wireless Products such as Outdoor Access Points and Mesh

networking devices etc., which are typically used at a distance of more than 20 cm away from human body.

INSTALLATION INSTRUCTIONS

1. Ensure that the Power is shut down before integrating the Module into the host system

2. Ensure that the antenna port is connected to the antenna that is designated to be used with this

module

3. Follow appropriate ESD precautionary measures

TECHNICAL SPECIFICATION

RADIO MODULE – GENERAL INFO

Chipset Info

Atheros AR9223-AC1A

Operating Frequency Range

902 MHz ~ 928 MHz

Security

WPA, WPA2, AES-CCM & TKIP Encryption, 802.1x, 64/128/152bit WEP

Data Rates

Legacy 11g up to 54 Mbps

11n HT20-1S up to 65 Mbps

6Mbps, 9Mbps, 12Mbps, 24Mbps, 36Mbps, 48Mbps,54Mbps

(Legacy IEEE802.11g)

1 Mbps,2 Mbps,5.5 Mbps,11 Mbps (Legacy IEEE 802.11b)

MCS0,MCS1,MCS2,MCS3,MCS4,MCS5,MCS6,MCS7 –IEEE 802.11n HT20

Single Stream

Channel Bandwidth

5 MHz/10 MHz/20 MHz

INTERFACE SPECIFICATIONS

Interface

PCI 32 bit,33 MHz, mini PCI Form Factor

Operating Voltage

3.3V

RF Antenna connector

Single MMCX, VERTICAL

OP FREQ

(MHz)

CH BW

(MHz)

STANDARD

907

5/10

11g/n

OPERATING CENTRE FREQUENCY MAPING

Summary of content (6 pages)

PAGE 1
RJ-1302 USER MANUAL MODEL RJ-1302 BRAND VIZMONET FCCID VJA-RJ1302 ICID 7382A-RJ1302 RJ-1302 is an IEEE 802.11b/g/n 902 MHz ~ 928 MHz Radio platform engineered for carrier class long range high data capacity applications. With superior TX power efficient RF design, the product supports high TX Power offering best-in class EVM performance at higher modulation schemes. This facilitates to achieve long range without compromising on data throughput.
PAGE 2
912 917 922 5/10/20 5/10/20 5/10 11b/g/n 11b/g/n 11g/n MECHANICAL DIMENSIONS Vizmonet Pte Ltd www.vizmonet.
PAGE 3
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 4
 The transmitter module may not be co-located with any other transmitter or antenna, IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain laptop configurations or colocation with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID cannot be used on the final product.
PAGE 5
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu'aucune autre antenne ou émetteur. Cet équipement devrait être installé et actionné avec une distance minimum de 20 centimètres entre le radiateur et votre corps.
PAGE 6
The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual.