LORAWAN Wireless Gas Transmitter RN320 Manual
Contents About This Manual Introduction Warning Major Feature Exterior Interior Accessory Specification Installation Setup Button LED Customer Service Information
About This Manual This document contains instructions for usage and installation of the RADIONODE® RN320 . Product specifications and certain features herein may be subject to change without prior notice. Figures used in this manual are for explanatory purposes only, and may differ from your system depending on installation conditions. Software screenshots may change after software updates Intellectual Property Rights © 2021 DEKIST Co., Ltd. All contents and figures herein are property of DEKIST Co.
Introduction RN320 Wireless gas transmitter is designed to measure temperature, humidity and CO2 gas and transmit them to the cloud system via lorawan. LORAWAN have different RF frequency for each countries. CH1 CO2 CH2 TEMP CH3 RH Warning This products have LORAWAN wireless protocol. user should have LORAWAN gateway (receiver). Without lorawan gateway, this product could not work properly. Major Features RN320’s Major features *LORAWAN is used for sending temp,RH and CO2 gas information.
Exterior Dimensions 115mm x 115 mm x 50 mm 1.Display 2.Front Button, 3.Status LED, 4.Bracket Connector Interior 1.Battery holder , 2.Gas Sensor , 3.
Accessory C Type 3.6V Bracket USB Cable Please Use same battery that is included in the box. Otherwise malfunction may be occured.
Specification RN320 wireless gas transmitter CO2 sensor : 0 ~ 2000 ppm temp. sensor : -40 ~ 80 ‘C RH sensor : 0 ~ 95% RH battery : 3.6V C Type Battery X 2 (parallel ) Wireless : LORAWAN FCC : 902.3 MHz ~ 914.9 MHz(125 kHz Bandwidth) 903 MHz ~ 914.2 MHz(500 kHz Bandwidth) CE : 863.1 MHz ~ 869.9 MHz(125KHz Bandwidth) 863.2 MHz ~ 869.85 MHz(250KHz Bandwidth Dimension : 115 X 115 X 50 mm Operation : -20’C ~ 60’C USB Type : USB C TYPE (USB C port is only for Installer or Engineer.
Installation Once you put the battery. RN320 device will turned on. there is no power switch on the device Bracket Attach the bracket on the wall firstly. turn RN320 15 degrees to the left and put it on the bracket. and then turn RN320 15 degrees to the right to fix it tight Battery two C type 3.6V battery is used for normal operation. please be aware that RN320 has no power switch. When pulling out the battery , this products would be working properly using internal super capacitor .
Setup In order to setup this products. connection PC (mobile) and RN320 via USB cable is required. Buttons Front button click change the display contents Zero calibration mode can be accessed pressing front button during 10 second LED RED : Initial Wireless Accessing, Warning gas level detected. GREEN : safe environment BLUE : Periodic measurement and RF transmission.
