Datasheet

5.2 Mechanical Performance Test
No evidence of mechanical damage.
≦± 0.5%
The resistor shall be mounted by its terminal leads to
the supporting terminals on the solid table.
The entire frequency range :from 10 Hz to 55 Hz and
return to 10 Hz, shall be transferred in 1 min.
Amplitude : 1.5 mm
This motion shall be applied for a period of 4 hours in
each 3 mutually perpendicular directions (a total of 12
hr)
Refer to JIS-C5201-1 4.22
Vibration
No evidence of mechanical damage.
≦± 0.5%
The tested resistor be immersed 25 mm/sec into
molten solder of 260 ± 5℃ for 10 ± 1 secs. Then the
resistor is left in the room for 1 hour , and measured its
resistance variance rate.
Refer to JIS-C5201-1 4.18
Resistance
to
Soldering
Heat
No evidence of mechanical damage.
≦± 0.5%
The tested resistor be immersed into isopropyl alcohol
of 20~25℃ for 60 secs, then the resistor is left in the
room for 48 hrs.
Refer to JIS-C5201-1 4.29
Resistance
to
Solvent
Solder coverage over 95%
Add flux into tested resistors, immersion into solder bath
in temperature 245± 5℃ for 3 ± 0.5 secs.
Refer to JIS-C5201-1 4.17
Solderability
SpecificationsConditionsItem
6
/
13
Page No.
2011
/
10
/
19
Released Date
IE-SP-022
Document No.
Metal Alloy Low-Resistance
Resistor Specifications
RALEC
旺 詮
Do not copy without permission
Issue Dep. DATA Center.
Series No.
60
IT’ S NOT UNDER CONTROL FOR PDF FILE
PLS NOTE THE VERSION STATED.
Remark