Instruction Manual

RallyArmorMudflapMountingInstructions‐2007+MitsubishiLancer

Pleasereadtheinstructionsthoroughlybeforeattemptingtomountthemudflaps.

RallyArmoralwaysrecommendsprofessionalinstallation.

Forhigherresolutionimagesandthemostuptodateinstructionspleasevisithttp://www.rallyarmor.com.

Toprotectandextendthelifeofyourrallymudflapsetcaremustbetakenduringparkingandreversing.

Yourmudflapsetcontains4flapstotalforallfourtiresofthevehicleFrontmudflap(4mountingholes)–Rearmudflap(3mountingholes).

Yourmountinghardwarehasbeenchecked.

Itconsistsof:

16PolygonEdgeClips…………………………………… (ItemPolCl)

16Washers…………………………………………………...  (ItemFenWash)

14ShortStainlessSteelScrews………….………… (Item1SS)

2LongStainlessSteelScrews…………………………. (Item1.5SS)

2RearLBrackets……………………………………………. (ItemRBRKT1)

2Spacers………………………………………………..……... (Item.5SP)

Recommendedtools:PhillipsScrewdriver(shortandoffset/ratchetingPhillips),Flatheadscrewdriver,Pliers,Drill&Drillbitset.



FrontMudFlapInstallation



leonanevensurface.Turnthesteeringwheeltowardsthesideyouareworkingontogainaccesstothewheel

the4factorywheelwellclips(#1‐#4)thatsecurethefenderlinertothevehicle.Toremovetheclips,poptheinnertaboutofthe

point(FigureB).Reinstalllinerover

1)Beginbyparkingthevehic

wellarea.

2)Remove

assemblyfirstthenremovethecompleteassemblybypryingtheouteredgesoftheclip(FigureA).

3)Pulllinerawayfromthebodyofthevehicleandplace4polygonclips(PolCl)overeachmounting

polygonclips,confirmingholesofpolygonclipsarealignedandvisiblethroughthemountingpointsoftheliner(FigureC).

  

4)Placefrontmudflap(has4holes)againstthevehiclemountingpointswithRallyarmorlogofacingtherearofthecar.Place1shortscrew

indthemudflaphole(thelogosideoftheflap)thatcorrespondstomountingpoint#4.Loosely



(1SS)throughawasher(FenWash)thenthroughthemudflapandintomountingpoints#1then#2then#3.Threadmountingpoints#1‐#3

loosely.*Donotfullytighten*(FigureD).

5)Tomountpoint#4,placethespacerbeh

threadalongscrew(1.5SS)throughawasher(FenWash),(FigureE).



1



Tip:RallyArmormudflaps



illflexandcurvetoconform

tothewallofsideskirt

equippedmodels.



PAGE 1
Rally Armor Mud flap Mounting Instructions ‐ 2007+ Mitsubishi Lancer Please read the instructions thoroughly before attempting to mount the mud flaps. Rally Armor always recommends professional installation. For higher resolution images and the most up to date instructions please visit http://www.rallyarmor.com. To protect and extend the life of your rally mud flap set care must be taken during parking and reversing.
PAGE 2
Tip: To properly align the flaps, walk towards the rear of the vehicle to view mud flap. Confirm the edge of the flap is perpendicular to the ground. If needed, incrementally shift the upper or lower portions of the flap. Always check each alignment you have performed by walking away from the vehicle and looking at the mud flap directly behind it in relation to the ground and the body of the vehicle. When flap is correctly aligned, fully tighten hardware only until snug. (Figure F).
PAGE 3
7) Working from the tire side towards the back, mount the mud flap to bracket by threading 1 short screw (1SS) through a washer (FenWash) then through mud flap mounting point into mounting point #8 (the polygon clip on L bracket hole B). *Do not fully tighten* (Figures M and N). 8) To align your mud flaps properly, walk away from the vehicle to view mud flap from behind. Confirm the edge of the flap is perpendicular to the ground.