Instruction Manual

  
7)Workingfromthetiresidetowardstheback,mountthemudflaptobracketbythreading1shortscrew(1SS)throughawasher(FenWash)
thenthroughmudflapmountingpointintomountingpoint#8(thepolygoncliponLbracketholeB).*Donotfullytighten*(FiguresMandN).
8)Toalignyourmudflapsproperly,walkawayfromthevehicletoviewmudflapfrombehind.Confirmtheedgeoftheflapisperpendicularto
theground.Ifneeded,makeslightadjustmentsbyincrementallyshiftingtheupperorlowerportionsoftheflap.Alwayscheckeachalignment
youhaveperformedbywalkingawayfromthevehicleandlookingatthemudflapdirectly ehinditmakingsureitisalignedtothegroundandb
tothebodyofthevehicle.Whenflapiscorrectlyaligned,tightenhardwareonlyuntilsnug(FigureO).
Tip:Thehardwareisquitestrongandselfthreadingbutover‐tighteningtheclipsbeyondtheirlimitisnotrecommended.
  
3



