Manual

2
bracket to vehicle body. Thread loosely to allow bracket adjustment later.
Tip: Confirm tip of screw does not interfere with any component behind the mounting point (Figure 1-A).
Tip: A short ratcheting screwdriver with bit will ease installation of inner screw (Figure 1-B)
Place clip over mounting slot on longer portion of the bracket to create mounting point #7 (Figure E).
3. Place rear mud flap with logo facing the rear of the vehicle with the outer mounting holes on the mud flap aligned to the corresponding
points on the vehicle. Thread medium screws (1SS) with washers through rear mounting points #4, #5 and #7. *Do not fully tighten* as
alignment must be checked before tightening the screws (Figure F).
4. Confirm the edge of the flap is perpendicular to the ground. If needed, make slight adjustments by shifting the upper or lower portions of
the flap. Check each incremental adjustment by walking away from the vehicle and looking at the mud flap directly behind in relation to the
ground and the body of the vehicle. When flap is correctly aligned, tighten hardware only until snug.
5. Repeat the instructions for the other side of the vehicle to complete rear mud flap installation.
Care tip: To preserve the finish of the flap, please observe caution when cleaning the flaps. Use water and a clean cloth; do not use solvent based
cleaners. Avoid fuel overflowing on to the rear flap.
Impreza GC 93-01 installation P . Ve r s i o n 1.0- 2.15.2009