Installation & Assembly

ASSEMBLY INSTRUCTIONS
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS
ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
1. Loosen knobs on harp (A).
2. Remove harp (B) from plastic bag and slide into top of harp.
3. Remove finial from harp (B). Place shade (not included) over the bolt attached
on the top of harp. Screw finial onto the bolt to secure shade to the harp.
4. Adjust harp (B), up or down, to get desired height. The socket should not show
under the shade when the harp is adjusted correctly.
5. Carefully tighten knobs on harp (A).
6. Insert light bulb into socket.
Beckford Table Lamp
Item # RL3467