Operating instructions

4. With the tool barrel closed to the semi-
closed position and finger away from
the trigger, open the cover by pressing
the side button, and insert a load disc
into the slots in the receiver housing.
5. Close the cover and be sure it is locked.
NEVER attempt to make a fastening
with the tool cover in the open or
unlocked position.
6. Hold the tool perpendicular (90°) to
the work surface with both hands and
press firmly to fully depress the tool.
Maintain firm downward pressure on
the tool with both hands and pull the
trigger to drive the fastener. DO NOT
DEPRESS THE TOOL AGAINST
ANYTHING OTHER THAN THE
INTENDED WORK SURFACE. Holding
the tool firmly in place will produce
more consistent fastening quality and
minimize tool wear or damage.
7. After making the fastening, with the
“tool pointed in a safe direction, pull
“the barrel fully open. This resets the
piston for the next fastening. Always
keep fingers and other body parts
away from the muzzle end of the
tool.
8. Insert another fastener in the muzzle
end of the tool as before and the tool
is ready for the next fastening. Keep
your finger off of the trigger until the
tool is in position to drive the fastener.
9. To remove a used or partially used
load disc from the tool, open the cover
and lift out the load disc. NEVER try
to remove a jammed or stuck load
disc. Should a “jammed” load disc
occur, call your local Authorized Ramset
Distributor for technical assistance.
TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
10
INSERT LOAD DISC INTO THE
SLOTS IN THE RECEIVER
HOLD TOOL FIRMLY AND PERPENDICULAR
TO WORK SURFACE
OPEN AND CLOSE THE BARREL
AND INSERT THE NEXT FASTENER
REMOVE THE LOAD DISC
90°