Instruction manual

VLF1 • 11
 12. Take the 36 AWG wire and cut it into 3, 20” pieces. Now, take 2 of
these pieces and twist the ends together about a half an inch. Slip one
end of the wire through one hole of the ferrite core, and the other end
through the other hole. It should now look like the figure below.
 13. Next, take one of the wires and wind it up through the opposite hole
and then down through the first hole as shown in the picture. Finally, route
it back through the second hole again.
 14. Repeat this 12 times. Remember to be delicate and loose with your
wiring. Snug the coils as much as you can without having to use anything
but gentle force on the wires.
 15. Now wind the second wire through the other hole in the same way.
Your transformer should now look like this: