2 in 1 HARDWOOD FLOORING CLEAT NAILER & STAPLER Model No: RMM4 INSTRUCTION AND TECHNICAL MANUAL
PARTS LIS T Item 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 Description Rubber cap O-ring 30.3 2.65 Screw Spring washer Cylinder cap Screw Spring washer Actuator part A Snap ring Half block O-ring 33.3 2.65 Actuator part B O-ring 57.4 3.5 Plunger O-ring 21 2 O-ring 14.2 2.5 Body Cylinder O-ring 17.5 2.6 O-ring 38.5 4.5 Poppet Piston assembly O-ring 58.7 3.
8.CONNECT TOOL TO AIR SUPPLY HOSE with a coupling that removes all pressure from the tool when the coupling is disconnected. Fig.4. EXPLODED VIEW DRAWING Fig.4 9.DISCONNECT TOOL FROM AIR SUPPLY HOSE before doing tool maintenance, clearing a jammed fastener, leaving work area, moving tool to another location, handing the tool to another person, or making adjustments. Fig.5. Fig.5 10.NEVER USE A TOOL that is leaking air, has missing or damaged parts, or requires repair.
anyone other than these agencies. Should you have any questions about your tool, feel free to us at any time. In any communications, please give all information shown on the nameplate of your tool (model number, type, serial number, etc.). TROUBLESHOOTING 1 4 . A L W AY S A S S U M E T H E T O O L CONTAINS FASTENERS. Keep the tool pointed away from yourself and o t h e r s a t a l l t i m e s . N o h o r s e p l a y. Respect the tool as a working implement. Fig.8. Fig.
Fig.25 SPECIFICATIONS Characteristic Minimum Operating Air Pressure Maximum Operating Air Pressure Staple Length Range Staple Size Staple Capacity L-shaped Nail Length Range L-shaped Nail Size L-shaped Nail Capacity Air Inlet Air Consumption Tool Weight Value 70 PSI 120 PSI 1" -- 2" 16 Gauge 92 1-1/2" -- 2" 15-1/2 Gauge 100 1/4" NPT 4.5 CFM 12 lbs A Fig.24 Fig.26 Fig.27 MAINTENANCE CLEAN AND INSPECT DAILY CAUTION: Disconnect tool from air supply before cleaning and inspection.
! ! ! NOTE: When Using Tool to install Pre-finished Flooring The RMM4 was designed for installing both unfinished and Pre-finished hardwood flooring. Care must be used however when installing pre-finished flooring to ensure that the finish is not damaged by the tool. It is recommended that the tool be inspected for damage [especially the base plate (A) Fig.17] and tested on a sample section to be certain that the tool and technique of use do not mar the finish.
PREPARING THE TOOL 1. After reading and understanding this entire manual, connect toolto air supply. (See Fig. 12). ! WARNING: Keep tool pointed away from yourself and others at all times. Always connect tool to air supply before loading fasteners. Always wear Z87 approved safety glasses, and hearing protection when preparing or operating the tool. Never use a tool that leaks air or needs repair. USING THE TOOL Complete all steps of PREPARING THE TOOL before using the tool.
