Manualshelf

Use and Care Manual

ManualsBrandsRamsond ManualsAir Compressors, Tools & Accessories2-in-1 Air Hardwood Flooring Cleat Nailer and Stapler Gun
1234567
IMPORTANT SAFETY INSTRUCTIONS
WARNING: When using pneumatic tools, basic safety precautions
should always be followed to reduce the risk of personal injury,
including the following:
READ AND FOLLOW ALL INSTRUCTIONS.
There are certain applications for which this tool was designed. we
strongly recommends that this tool NOT be modified and /or used for
any application other than for which it was designed. If you have any
questions relative to its application DO NOT use the tool until you have
written us and we have advised you.
1
!
PARTS LIST
12
Item
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
Description
Rubber cap
O-ring 30.3 2.65
Screw
Spring washer
Cylinder cap
Screw
Spring washer
Actuator part A
Snap ring
Half block
O-ring 33.3 2.65
Actuator part B
O-ring 57.4 3.5
Plunger
O-ring 21 2
O-ring 14.2 2.5
Body
Cylinder
O-ring 17.5 2.6
O-ring 38.5 4.5
Poppet
Piston assembly
O-ring 58.7 3.5
Bumper
Seal
Arm
Air plug
Sleeve
Screw
Guide body
Pin
Front plate
Screw
Screw
Item
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
Description
Spring washer
Washer
Protect block
Pin
Screw
Base plate
Screw
Pad
Washer
Feeder assembly
Spring bracket
Screw
Fixed magazine A
Washer
Screw
Screw
Plate
Limit nut
Stopped plate A
Screw
Screw
Fixed magazine B
Bushing
Spring
Pin
Movable magazine
Hex key
Sheath
Rail A
Oriented plate
Rail B
Sleeve
Stopped plate B
Pull handle
1.USE SAFETY GLASSES. To
prevent eye injuries, the tool operator
and all persons in the work area must
wear safety glasses with permanently
attached, rigid, plastic side shields.
These safety glasses must conform to
ANSI Z87.1 requirements (approved
glasses have “Z87” printed or stamped
on them). Fig.1.
2.WEAR EAR PROTECTION to
safeguard against possible hearing
loss. Fig.1.
3.OPERATOR AND BYSTANDERS
WEAR HARD HAT to safeguard against
possible injuries. Fig.1.
4.USE CLEAN, DRY, REGULATED
compressed air at 70 to 120 PSI, (4.8 to
8.3 BAR ). Fig.2.
5.DO NOT CONNECT TOOL to
pressure which potentially exceeds
200 PSI (13.8BAR)
6.ONLY USE AIR HOSE THAT IS
RATED for a maximum working
pressure of 150 PSI or 150% of the
maximum system pressure, which
ever is greater.
7.NEVER USE OXYGEN, CARBON
DIOXIDE, combustible gases or any
other bottled gas as a power source for
this tool: explosion and serious
personal injury could result. Fig.3.
Fig.2
Fig.3
Z87
Fig.1