Operator`s manual

OperatOr’s Manual
RAMTEQ
®
14275 NORTHWEST FREEWAY  HOUSTON, TX 77040  PHONE: [phone]  FAX: [phone]  300-00010-01 7/06
page 6
LOCATION GUIDELINES
 Locate the machine on a solid and level surface so that engine and pump crankcase oil lubricate components properly.
Avoid areas where water can build up in the working area. Possible injury can occur caused by the surface becoming
slippery from water build up.
 Locate the machine in a well-ventilated area and away from flammable materials or fumes. Be sure ventilation warnings
are observed. Keep pressure washer at least 18” away from flamable materials.
 Locate the machine so the operator has easy access to the jetter/pressure washer and its controls. Locate the machine
so that it is protected from external damage.
 To prevent damage and excessive hose wear, locate the unit so that the hose does not cross traffic areas.
STARTING THE MACHINE
Following the steps below will insure successful operation:
 Read this manual completely before attempting to start the machine.
 Check the fuel tank and fill with a good grade of gasoline (87 octane minimum) for gas engines and a high quality diesel
fuel for diesel engines.
 Check the engine oil level and fill with SAE 30 weight high-detergent oil.
 Check the pump oil level and fill with SAE 30w non-detergent oil if needed.
 Check water tank to ensure adequate level of water required for the job.
 Pull trigger on gun until a steady stream of water comes out the nozzle. This purges any air in the system.
 Slide fuel switch to the RIGHT and slide choke switch to the LEFT (closed position).
 Turn ON/OFF switch (on engine) to “ON”.
 Open water flow to reduce back pressure in pump. Back pressure can overpower electric starter, preventing ignition.
 Turn key to start gas engine and allow RPM to develop.
 Let engine warm up for approximately 30 seconds and slide choke to “OPEN” position.
 Check for leaks in the system and cycle trigger gun to insure bypass is adjusted correctly. Repair any leaks and correct
unloader adjustment if needed. Turn off machine before attempting any repairs.
 WARNING - Do not operate machine with less than 6" of water in the tank. Doing so may cause pump damage!
STOPPING THE MACHINE
 Turn engine to “OFF”.
 Pull gun trigger to release water pressure from system.
 Disconnect wand & gun assembly.
 Wind up pressure hose on hose reel.
CAUTION
 Always wear protective safety gear, auch as, but not limited to, rain coat or coveralls, rubber boots, face shield or
goggles, gloves and hearing protection.
 Do not run the machine for more than two minutes with the jetter water flow shut off (by-pass mode). This will over
heat the jetter pump and could cause injury to you.
 Do not run hot water thru this pump. Hot water will damage the pump, and will void the warranty.
Operating Instructions