Operator’s Manual CH SERIES Gas Engine / Diesel Fired READ THIS MANUAL This manual contains important information for the use and safe operation of your RAMTEQ machine. FAILURE TO READ THIS MANUAL AND FOLLOW ITS INSTRUCTIONS PRIOR TO OPERATING OR ATTEMPTING ANY SERVICE OR MAINTENANCE PROCEDURE COULD RESULT IN SERIOUS INJURY OR DEATH TO YOU OR OTHER PERSONS; ALSO DAMAGE TO THE MACHINE OR TO OTHER PROPERTY.
Operator’s Manual Page Table of Contents Section 1 Operator’s Manual Unpacking....................................................................2 Safety Instructions and Warnings.............................3 Maintenance Instructions...........................................4 Operating Instructions...............................................6 Section 2 Parts and Service Manual Parts List....................................................................
Operator’s Manual Page Safety Guidelines � WARNING READ THIS FIRST! Failure to read and observe all WARNING statements could result in severe bodily injury or death, possible injury to other persons, damage to machine or other property. DO NOT operate this machine in areas where open flames are not permitted. DO NOT store or use combustible materials on or near this machine. Use this equipment only in well ventilated areas.
Operator’s Manual Page Maintenance Instructions MAINTENANCE PRECAUTIONS Do not permit acidic, caustic or abrasive fluids to be pumped through system. Periodically clean detergent inlet screen. This will ensure proper flow of water to the pump. High mineral content in water may adversely affect your machine and may require the use of a water softener to ensure proper operation. NEVER run the pump dry under any circumtances. Doing so will cause exteme damage to the pump.
Operator’s Manual Page Maintenance Instructions ELECTRODE SETTINGS Inspection of all wires, spring contacts and electrodes should be done periodically. � WARNING IF BLACK OR WHITE SMOKE VENTS FROM EXHAUST PORT UPON STARTING EQUIPMENT, DISCONTINUE USE AND ADJUST AIR BANDS BEFORE RESTARTING. OIL BURNER AIR BAND ADJUSTMENT RAMTEQ sets oil burners at sea level. Air bands may need adjustment at higher elevations to offer eCHanced performance of the burner and extended life of the machine.
Operator’s Manual Page Operating Instructions LOCATION GUIDELINES Locate the machine on a solid and level surface so that engine and pump crankcase oil lubricate components properly. Avoid areas where water can build up in the working area. Possible injury can occur caused by the surface becoming slippery from water build up. Locate the machine in a well-ventilated area and away from flammable materials or fumes. Be sure ventilation warnings are observed.
Operator’s Manual Page CH Parts List 9 Ref.
Operator’s Manual Page 5 4 6 7 8 3 9 CH 12v Burner Assembly 2 1 11 10 Ref# 1 2 3 3a 4 5 6 7 8 9 Part # Description Qty 256-00001-02 Main Burner Gasket 253-00002-01 Fan Wheel 3.44” x 4.25” 254-00001-04 Motor, 12v DC Motor, Flange 252-00001-04 Ignitor 253-00001-01 Coupling 251-00001-01 Fuel Pump Suntec 245-00006-16 Fuel Nozzle 2.
Operator’s Manual Page CH Control Box Assembly Ref.# Part # Description Qty 1 2 3 4 5 6 7 180-00027-01 305-00006-01 450-00001-01 573-00001-01 505-00001-01 508-00002-01 180-00150-01 Control Box Panel Label, Control Box Small Pump/Burner Switch On/Off Thermostat Assembly 1/4" X 20 Thumb Screw Tinnerman Control Box 1 1 1 1 2 2 1 1 Hose, Wand & Gun 7 4 3 5 2 6 10 8 9 RAMTEQ ® Ref# Part# Discription Qty 1. 1a. 1b. 1c. 1d 1e. 1f. 1g. 1h. 1f. 1g. 1h.
Operator’s Manual Page 10 1 CH Belt Drive Pumps 2 General Pump TS2021-R Triplex Plunger Pump Pump Repair Parts Ref# 1. 2.
Operator’s Manual Page 11 CH Wiring Diagram BURNER MODULE “Small” BLK RED WHT BLK BLOWER “Big” RED IGNITOR XFMR yellow - N.O.
Operator’s Manual Page 12 CH Wiring Diagram CH - no generator W/ HOUR METER Burner Module A INDICATES CONTROL BOX KANBAN A INDICATES FINAL ASSY TASK HOUR METER See separate sheet A INDICATES POWER PLATE KANBAN A INDICATES ASSEMBLED FROM OTHER AREAS A BLK CONTROL PANEL WHT WHT 10 RED AC + C HOUR METER BURNER SW BLK WHT WHT D - AC BLK 87 86 85 1 PI 30 6 RED 8 THERMOSTAT RED 9 RED 4 BRN B 3 5 1 RED GRN WHT BLK PRESSURE SW F 7 E Attach to engine mounting bolt ST
Operator’s Manual Page 13 CH Wiring Diagram ELECTRICAL SCHEMATIC CH W/ GENERATOR Burner Mtr Burner Module Transformer for Ignitor ORG WHT Grn Wht Blk Red Fuel Solenoid HOURMETER GRN WHT BLK BLK WHT BURNER SWITCH RED BLK RED 1 P THERMOSTAT N.C. BLK BLK WHT GRN GRN SMOOTH WIRE= BLK RIBBED WIRE=WHT PRESSURE SWITCH WIRE STRIP JACKET BACK 5 INCHES BLK BLK PRESSURE SWITCH 5/14/98 115v Rt Angle Plug RAMTEQ ® 14275 northwest freeway Houston, TX 77040 phone: 713.983.
Operator’s Manual Page 14 CH Pump Plumbing CH BASE MODELS: CH1100-01 CH1100-03 CH1300-01 CH1300-03 CH1600-01 NIPPLE, GALVANIZED STEEL 1/2 NPT X 2.5" 526-00005-01 QUICK CONNECT COUPLER 3/8 NPTM X 3/8 MALE 552-00002-01 NIPPLE, GALVANIZED STEEL 1/2 NPT X 2.
Operator’s Manual Page 15 troubleshooting problem Low Water Pressure cause action Insufficient water source Old or incorrect nozzle Plumbing or hose leak Obstruction in spray nozzle Chemical valve open Unloader valve worn Pump valves dir ty or worn Check hose size/water source Replace nozzle Tighten, repair or replace leak Clean or replace nozzle Close valve or submerge hose Replace unloader Clean or replace packing/valves No Chemical Flow Detergent valve closed Low detergent le
RAMTEQ Limited One Year WARRANTY Ramteq Incorporated ("RAMTEQ") warrants that the Product you have purchased from RAMTEQ or from an Authorized RAMTEQ Reseller is free from defects in materials or workmanship under normal use for a period of one (1) year from the date of purchase. This warranty extends only to you, the original Purchaser. It is not transferable to anyone who subsequently purchases the Products from you.
Ramteq Manufacturers Warranty Period Click on pictures to open manufacturers website. 5 years 5 years 3 years 3 years 3 years 3 years 18 months 18/36 months Ramteq Pressure Washers 14275 NORTHWEST FREEWAY HOUSTON, TX 77040 1 year PHONE: 713.983.6000 FAX: 713.983.