Owners manual

14
11)  Attach OE brake line bracket to bracket 176625
using two M8-1.25 x 20 mm bolts, two Nylock nuts and
four M8 washers from 860696. See illustration #27
Torque to 23 ft-lbs.
Illustration #27
16)  Install rear wheels and lower vehicle to ground.
Tighten the lug nuts to 140 ft-lbs.
FINAL CHECKS & ADJUSTMENTS
1)  Jounce suspension and move the vehicle to
normalize ride height. Verify that the front spindle to
fender height is 29 to 29.5” and that both sides are
equal. If necessary, reinstall GM tool CH48809 and
adjust the tension on the torsion bars to correct the
height.
2)  Turn the front wheels completely left then right.
Verify adequate tire, wheel, and brake hose clearance.
Inspect steering and suspension for tightness and proper
operation.
3)  With the suspension at maximum extension
(full droop), inspect and rotate all axles and drive shafts.
Check for binding and proper slip yoke insertion. The
slip yoke must be inserted a minimum of one inch into
the transfer case and/or transmission.
4)  Ensure that the vehicle brake system operates
correctly. If new brake hoses were installed, verify that
each hose allows for full suspension movement.
5)  Readjust headlamps. Have vehicle aligned at a
certified facility.
Recommended Alignment Specifications
Caster (degrees): 3.1° – 3.6° ± 0.1° left to right
Camber (degrees): 0.3°± 0.6°
Sum Toe (inches): 0.10 ± .20
Please retain this publication for future reference. See Important Note P.
176625 OE Nut
M8-1.25 x 20mm
OE Bracket