Owners manual

14
BRAKE LINE BRACKET INSTALLATION
1)  Attach the new brake line bracket 170014 to the
rear differential with the 8mm hardware from kit
860569. See illustration 24.
2)  Carefully reshape the brake line and attach the
junction block to the top of bracket 170014. Use the
5/16” hardware from kit 860569.
3)  Reattach the brake line to the rear axle with the
two original bolts.
Illus. 24
FINAL CHECKS & ADJUSTMENTS
1)  Turn the front wheels completely left then
right. Verify adequate tire, wheel, and brake hose
clearance. Inspect steering and suspension for
tightness and proper operation.
2)  With the suspension at maximum extension
(full droop), inspect and rotate all axles and drive
shafts. Check for binding and proper slip yoke
insertion. The slip yoke should be inserted a minimum
of one inch into the transfer case and/or transmission.
3)  Ensure that the vehicle brake system operates
correctly. If new brake hoses were installed, verify
that each hose allows for full suspension movement.
4)  Readjust headlamps. Have vehicle Aligned at
a certified alignment facility.
Recommended Alignment Specifications
Caster (degrees): 4.5° ± 1.0°
Camber (degrees): 0° - neg .3°
Sum Toe In (degrees): .1° ± .2°
Please retain this publication for future reference.
See Important Note Q.