Owners manual

ManualsBrandsRancho ManualsAutomotiveRS98510 Steering Stabilizer; Dual Kit

Rancho Suspension 1 88058 REV B

INSTALLATION INSTRUCTION

88058

Rev B

RANCHO DUAL STEERING STABILIZER KIT RS98510

— This kit will work only on vehicles with at least a 2” lift and 2" tall front bump stop spacers (not included).—

READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING INSTALLATION

Parts List

Part No. Description Qty

176345

Axle Bracket

176359

Tie Rod Bracket

5405

Stabilizer Shock

Boot

Tie Wrap

Rancho Decal

P00932

Parts Package

Mounting Stud

1/2

20 Nut

7/16

20 Nut

1/2 Lock Washer

7/16 Lock Washer

I/2 Flat Washer

7/16 Flat Washer

Part No. Description Qty

P01134

Parts Package

Retainer

Cushion

3/8

16 Nylock Nut

860533

bolt Hardware Kit

Axle U

bolt

5/16

x 1.

x 2.75 U

bolt

3/8

16 Nyloc Nut

3/8 SAE Washer

5/16

18 Nyloc Nut

5/16 USS Washer

88058

Instruction

1) Park the vehicle on a level surface and set the parking

brake. Place the front wheels in a straightforward

position.

2) Loosen the nuts on the drag link adjusting sleeve

clamps. Remove the bolt on the adjusting sleeve

bracket. See illustration 1.

Illus. 1

3) Without moving the adjusting sleeve, turn the clamps

until the bolts are vertical and on the front. Slide

bracket aside and file a notch on the drag link for the

bracket bolt.

4) Reposition bracket and install hardware. Tighten the

adjusting sleeve nuts to 41 ft. lbs. and the bracket nut

to 13 ft. lbs.

5) Place axle bracket 176345 on the front of the axle

housing above the tie rod adjusting sleeve. See

illustration 2. Loosely attach the bracket to the axle

with the large U-bolts from kit 860533.

Illus. 2

6) Slide the axle bracket against the edge of the front

differential. Rotate the bracket 1/4” away from the tie

rod adjusting sleeve. Tighten the u-bolt nuts to

35 ft. lbs.

Summary of content (2 pages)

PAGE 1
INSTALLATION INSTRUCTION 88058 Rev B RANCHO DUAL STEERING STABILIZER KIT RS98510 — This kit will work only on vehicles with at least a 2” lift and 2" tall front bump stop spacers (not included).— READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING INSTALLATION Parts List Part No.
PAGE 2
7) Loosely attach tie rod bracket 176359 to the top of the tie rod end with the small U-bolts from kit 860533. See illustration 3. 8) Loosely attach the rod end of new stabilizer shock 5405 to the tie rod bracket. Use the supplied bushings and hardware from parts package P01135. 9) Attach the barrel end of the stabilizer shock to axle bracket 176345 with the hardware from parts package P00932. Tighten nuts and bolts to 45 ft. lbs. 10) Rotate tie rod bracket 176359 slightly down in the front.