Instructions / Assembly

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This device complies with FCC SAR exposure limits set forth for an uncontrolled environment.
SAR compliance for using the equipment in close proximity to the human body has been
evaluated at 0mm.
This equipment must not be co-located or operating in conjunction with any other antenna
or transmitter.
End-users and installers must be provide with antenna installation instructions and consider
removing the no-collocation statement.
Caution!
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Canada Statement
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
This equipment should be installed and operated with a minimum distance of 0mm between
the radiator and your body.
Cet équipement devrait être installé et actionné avec une distance minimum de 0mm entre
le radiateur et votre corps.
This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
Cet émetteur ne doit pas être Co-placé ou ne fonctionnant en même temps qu'aucune autre
antenne ou émetteur.
LE-LAN devices are restricted to indoor operation only in the band 5150-5250 MHz.
However, original equipment manufacturer (OEM) devices, which are installed in vehicles by
vehicles manufacturers, are permitted.
Les périphériques LE-LAN sont limités au fonctionnement en intérieur uniquement dans
la bande 5150-5250 MHz. Cependant, les dispositifs du fabricant d'équipement d'origine
(OEM), qui sont installés dans les véhicules par les fabricants de véhicules, sont autorisés.
This radio transmitter (IC: 10199A-1000DA) has been approved by Industry Canada
to operate with the antenna types listed below with the maximum permissible gain
indicated. Antenna types not included in this list, having a gain greater than the
maximum gain indicated for that type, are strictly prohibited for use with this device.
Function Frequency Model Type Connector Gain(dBi)
FM Tx 98MHz ANECRA1-CNC00-EF Dipole SMA -10
BT 2.45GHz ANTP1M1-CNC11-EH PIFA IPEX 1.17
WiFi 2.4 2.45GHz ANTP1M1-CNC11-EH PIFA IPEX 1.17
WiFi 5 5.25GHz ANTP1M1-CNC11-EH PIFA IPEX -2.28
GPS 1.575GHz ANTP1M1-CNC09-EH Dipole IPEX 1.63
XM Radio 2.332GHz R16-A082 Patch SMB -1
Antenna Information