Use and Care Manual

OverDryve
™
Pro User Manual 48
SiriusXM Radio
Your OverDryve Pro tablet comes with a SiriusXM radio app pre-installed. To
access SiriusXM,, tap Entertainment > SiriusXM. The SiriusXM antenna
cable must be installed, and the tablet connected to the Smart Mount.
Antenna Cable Routing
When routing antenna cable, always be careful to include enough slack
in your cable to accommodate open doors and driver space. Use things
typically found around the home, like electrical tape, to secure cables in
areas so that hinges do not pinch the cable with the door. Hide any excess
cable in the cabin trim.
Activating Your Radio
After installing your OverDryve Pro tablet with SiriusXM smart mount and
the antenna, launch the SiriusXM application from the ENTERTAINMENT
category. You should be able to hear the SiriusXM preview channel on
Channel 1. If you cannot hear the preview channel, please check the
installation instructions to make sure your SiriusXM smart mount tuner is
properly installed.
After you can hear the preview channel, tune to Channel 0 to nd the Radio
ID of your tuner. In addition, the Radio ID is located on the bottom of the
SiriusXM smart mount tuner. You will need this number to activate your
subscription. Write the number down for reference. Note: the SiriusXM
Radio ID does not include the letters I, O, S or F.
In the USA, activate online or by calling SiriusXM Listener care:
www.siriusxm.com/activatenow or 1-866-635-2349
For Canadian Subscriptions, please contact:
www.siriusxm.ca/activatexm or 1-877-438-9677
The SiriusXM satellites will send an activation message to your SiriusXM.
When your radio receives the activation message, your radio will display
“Subscription Updated” Note, the activation process usually takes 10 to 15
minutes, but may take up to an hour. Your radio will need to be powered on
and receiving the SiriusXM signal to receive the activation message.
11. Entertainment