ELECTRONIC LOGGING DEVICE User Manual
Installing Your HD 100 > Installation Instructions Installing your HD 100 can take as little as 10 minutes. Installation instructions are provided here, as well as quick diagnostic information so you can verify your device is working correctly. Installation Instructions 1. Locate the truck’s diagnostic port. Connect the cable to the port and turn the collar on the cable end to lock it in place.
Installing Your HD 100 > Installation Instructions 3. Connect the HD 100 to the cable and place it (with the tray attached) on the flat surface. 4. Make sure the area selected is clean and dry. Peel the protective layer off one side of the adhesive mounting strips and place on the bottom of the HD 100 tray. Then peel off the other protective layer, and place the device with tray attached on your dash in the desired location, pressing firmly to secure it to the dash surface.
Installing Your HD 100 > Installation Instructions 5. Once the HD 100 device is mounted and connected to the vehicle, turn on your engine. The four colored lights on the side of the device should illuminate within about 20 seconds, indicating that the device is connected and running properly. For more information on how the colored lights work, refer to the Quick Diagnostics section on page 12. 6. Now, mount your IntelliRoute® TND™ 720, if it is not already.
Installing Your HD 100 > Quick Diagnostics Quick Diagnostics Once your HD 100 and IntelliRoute® TND™ 720 are installed in your truck, follow the Quick Diagnostic steps to ensure your system is working properly. 1. Verify HD 100 Connectivity. • Ensure the four colored lights are on. These lights indicate that the HD 100 is connected and running properly. • The JBus (Blue) light should turn on soon after connecting.
Installing Your HD 100 > Quick Diagnostics Power Cell (Red) (Green) On Device Powered On Flashing System alert (HOS alerts) Off No power/device turned off On Connected Flashing Attempting to connect Off Not connected On Connected Flashing Attempting to connect Off Not connected JBus On Connected (Blue) Off Not connected Power (Red) Wi-Fi® JBus (Yellow) (Blue) Wi-Fi® (Yellow) External Antenna Port* Power Port Mini-USB Port Reset Button *For use with external antenna when instal
Installing Your HD 100 > Alternative Installation Options Alternative Installation Options Accessories and parts for alternative installations can also be purchased at randmcnally.com/fleetaccessories. Contact Rand McNally Customer Support at 1-800-641-RAND (7263) or fleetsupport@randmcnally.com for more information on alternative installation options.
Installing Your HD 100 > Troubleshooting Troubleshooting This section covers basic troubleshooting scenarios. For the most up-to-date troubleshooting information, refer to randmcnally.com/HD100troubleshooting. NOTE: To remain compliant, you must keep paper logs if your HD 100 or IntelliRoute® TND™ 720 is not functioning properly. Red light is off for more than 3 minutes after connecting HD 100 to diagnostic port (No power on HD 100 device): • Check power connection on HD 100 device.
Installing Your HD 100 > Troubleshooting Yellow or Green lights stay off for more than 3 minutes after connecting HD 100 to diagnostic port (Wi-Fi® or Cell not connecting on HD 100 device): • Make sure your IntelliRoute® TND™ 720 device is charged and within 10 feet of the HD 100 device. • Push the Reset button on the side of the HD 100 device. • Check power connection on HD 100 device. - Ensure the cable is secured to the truck’s diagnostic port and to the HD 100 device.
