Owner's Manual

11
HD 100 User Manual
Installing Your HD 100 > Quick Diagnostics
Quick Diagnostics
Once your HD 100 and IntelliRoute
®
TND
™
720 are installed in your
truck, follow the Quick Diagnostic steps to ensure your system is
working properly.
1. Verify HD 100 Connectivity.
• Ensure the four colored lights are on. These lights indicate that
the HD 100 is connected and running properly.
• The JBus (Blue) light should turn on soon after connecting.
• If the Power (Red), Wi-Fi
®
(Yellow), or Cell (Green) lights remain
flashing or off for more than 3 minutes after you connect your
HD 100 device to the diagnostic port with the power cable, then
there may be an error. Refer to the Troubleshooting section on
page 14.
2. Confirm access to HD 100 Home Menu.
• Click the HD 100 icon on IntelliRoute
®
Home Menu.
• Log into the HD 100 software with your Driver ID.
• Confirm that the HD 100 Home Menu screen is visible.
3. Once you log on to the HD 100 software, confirm Cell
icon is visible on status bar. For more information on the
status bar, refer to page 24.
4. Once you log into the HD 100 software, verify GPS and
ECM connectivity.
• Select the Diagnostics tab, then the GPS sub-tab. Confirm GPS
status is good by verifying that there are values in the Latitude
and Longitude fields. For more information on the Diagnostics
tab, refer to page 52.
• Drive the truck at least 0.2 miles. Select the SysInfo icon from the
HD 100 Home Menu. Select Diagnostics, then the JBus sub-tab.
• Confirm that there is an odometer value in the Eng. odom. field.
Once you confirm all of these items are operating correctly,
the system is ready to use.