VIDEO CHANNEL CURSOR LINK CHANNEL 2 CHANNEL 1 1: 2: 88.8 FRAMES 88.8 FRAMES 23.
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with manufacturer’s instructions. 8. Do not install near any heat sources such as radiators, registers, stoves, or other apparatus (including amplifiers) that produce heat. 9.
OPERATORS MANUAL AD22S AUDIO DELAY DISTANCE STORE CURSOR CHANNEL 1 ALIGNMENT VIDEO RANE AD 22S AUDIO DELAY CHANNEL 2 CHANNEL COARSE LINK FINE 1 MEMORY RECALL BYPASS 2 1 1 SIG OL 2 2 AD22S AUDIO DELAY QUICK START Your AD22S is out of its box, and now it’s time to integrate it with your audio setup.
FRONT PANEL DESCRIPTION 5 4 DISTANCE CHANNEL 1 1 RANE AD 22S AUDIO DELAY COARSE CHANNEL 2 CHANNEL 0 1 STORE CURSOR ALIGNMENT VIDEO 7 FINE LINK MEMORY BYPASS RECALL 2 3 6 2 8 1 1 SIG OL 2 2 AD22S AUDIO DELAY 9 1 ALIGNMENT MODE buttons: Press DISTANCE for delay in feet, meters, or milliseconds. Press VIDEO for alignment by frames or milliseconds. 2 CHANNEL button: Press this to switch the cursor location between channels. This button has no effect if the channels are linked.
REAR PANEL DESCRIPTION 1 RECALL 6 CH 1 REMOTE BYPASS 100-240 V 50/60 Hz 7 WATTS USB CH 2 REMOTE RECALL ACN 001 345 482 FRONT PANEL CONTROL LOCKS DELAY R This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. BYPASS AD22S MADE IN U.S.A. RANE CORP.
OPERATING DETAILS INITIAL SETUP The AD22S is always on while plugged in. When first powered up, the LCD briefly displays the words “Rane AD22S Audio Delay” and the current firmware revision. Out of the box, both channels are in BYPASS mode with the inputs routed directly to the outputs. This makes it easy to set up and verify that signals are present before turning on any delay. The yellow bypass indicators mean that BYPASS is active; press each BYPASS button to disable.