User Manual

7
10. Touch Strip: This pressure sensitive strip replaces the tone arm and allows the user to set
track position depending on the Touch Strip Mode setting.
11. Touch Strip Mode: Press this button to toggle the Touch Strip between Needle Drop and
Hot Cue modes. When Needle Drop is selected (default when Twelve is powered on), the
button will be dimly lit. When Hot Cue is selected, the button will be brightly lit.
• Needle Drop Mode
i. Press the Cue Mode button so it is dimly lit. (This is the default mode when
Twelve is first powered on.)
ii. The length of the Touch Strip represents the length of the entire track. Place
your finger on a point along this sensor to jump to that point in the track. White
LEDs on the Touch Strip will give a visual representation of the position of the
needle in the track.
• Hot Cue Mode
i. Press the Cue Mode button so it is brightly lit.
ii. When a section of the Touch Strip is unlit, you can assign a Hot Cue Point by
pressing it at the desired point in your track. Once it is assigned, the section
will light. The software determines the color of the Hot Cue Point.
iii. While the track is playing, press the Hot Cue Point to return the track to that
point.
iv. To delete a Hot Cue Point, press and hold the Cue Mode button and press the
section you would like to delete.
12. Deck Select: Selects which deck in the software is controlled by Twelve. Up to four
Twelve controllers can be connected with a Serato DJ Pro-enabled device provided the
device has enough channels. For instance, if you are using a two-channel mixer such as
the Rane Seventy-Two, only up to two Twelve controllers can be connected and only the
first 2 channels will be available for selection. When you are using more than one Twelve
controller at a time, you will need to determine which deck each controller is assigned to:
i. Power on each controller. The available Deck Select buttons on all connected
Twelve controllers will flash.
ii. Press the Deck Select button that corresponds to which deck you would like to
assign each Twelve to. Once a Deck is selected and in use, the button LED will be
fully lit, and buttons for other available decks will enter a dim state.
iii. To switch to another available deck, press the corresponding Deck Select button.
iv. To unselect a deck, press and hold the corresponding Deck Select button for 2
seconds. When buttons for the available decks start flashing, you are ready to select
a new deck.