User Manual

Manual-3
REAR PANEL: STEREO 2-WAY INSTALLATION
Observe the labels above the Inputs and Outputs for Stereo operation.
햲 CHANNEL 1 INPUT: Plug the left output of the mixer, equalizer or other signal source to this Input. See ‘AC 23B
Connection’ on page Manual-1 for wiring details.
햳 CHANNEL 2 INPUT: Plug the right output of the mixer, equalizer or other signal source to this Input..
햴 HIGH FREQUENCY OUTPUTS: Connect the CHANNEL 1 HIGH OUT to the left channel input of the high frequency
amp, and the CHANNEL 2 HIGH OUT to the right channel input of the high frequency amp.
햵 MID FREQUENCY OUTPUTS: Connect the CHANNEL 1 MID OUT to the left channel input of the low frequency
amplifier, and the CHANNEL 2 MID OUT to the right channel input of the low amplifier.
햶 2-WAY/3-WAY switch: Converts the outputs from 3-Way to 2-Way. This switch removes the Low frequency crossover
from the signal path. Low frequencies are now routed to the Mid frequency Output. Be sure to slide the switches to the
2-WAY position. Note: The Low frequency outputs are still active and may be used as additional subwoofer outputs.
햷 STEREO/MONO switch: Set this switch to the STEREO “out” position.
햸 POWER input connector: Use only a model RS 1 or other power supply approved by Rane. This unit is supplied with a
remote power supply suitable for connection to this input jack. This is not a telephone jack. The power requirements call for
an 18-24 VAC center-tapped transformer only. Using any other type of unapproved supply may damage the unit and void
the warranty. Two years parts and labor is worth safeguarding.
햹 Chassis ground point: A #6-32 screw is used for chassis grounding purposes. Always connect crossover chassis ground to
amplifier chassis ground. See ‘Chassis Grounding’ on page Manual-7 for details.