Specifications
Manual-10
LIMIT THRESHOLD and Headroom Meter
In addition to the Compressor / De-esser, each channel of the 
C4 features an independent, brick-wall Limiter with an instanta-
neous attack time, xed 25 ms hold time and a xed 6 dB/sec-
ond release rate. e C4’s limiter uses oversampling in order to 
ensure high frequency transients are properly detected and acted 
upon.
e Headroom meter displays the dierence, in dB, between 
the LIMIT THRESHOLD and the present signal level. For 
example, with LIMIT THRESHOLD set to +10 dBu, a peak 
signal level of +4 dBu results in a display of 6 dB of remain-
ing headroom (+10 dB minus +4 dB equals 6 dB). e LIMIT 
indicator lights when the present signal exceeds the set Limit 
reshold. When setting the Limiter reshold keep in mind 
that music often has peaks which are 12 to 20 dB higher than 
the average (rms) value, which is displayed on the side-chain 
meter.
Note: e Limiter is active at all times and is not aected by 
the bypass switch. To bypass the limiter, simply rotate the Lim-
iter reshold control fully clockwise (+22 dBu setting).
6
3
12
24
dB
-20
-10
0
-40
-30
+22
+10
dBu
Headroom
LIMIT THRESHOLD
LIMIT
Initial Settings
Sometimes it is necessary to start from scratch. e drawing 
above shows where to set the controls for no processing (the 
black knobs have no aect at this point). en you can adjust 
each section one at a time.
Suggested Settings
ere is no magic recipe of compressor settings which work for 
every audio source in every performance situation. ere are, 
however, a few key ingredients you can add to the ol’ dynam-
ics stew to get things going. Start with the suggested settings in 
Table 1, then season to taste by adjusting the reshold until 
your ears tell you it’s just right.
Vocals
A tough issue with vocals is the extreme dynamic range of some 
singers. ose who can lull you to sleep and then scare you with 
an unexpected blast. e dierence between the soft crooning 
and the loud climax represents too much signal change for many 
preamps and mixers, causing them to clip and distort badly. 
Compression and limiting comes to the rescue.
Use the limiter to prevent the extreme levels from causing 
clipping and distorting the sound. With its automatic fast attack 
and quick release mode, all you need to set is the Limit resh-
old. Set it as high as the next piece of equipment in the signal 
path allows. e C4 gives you a wide setting range of -40 to +22 
dBu that covers all requirements.
Compression is one of the most eective tricks for bring-
ing the vocals up in any mix, live or recorded. is is due to 
the increase in perceived loudness which results from reducing 
peaks and increasing the average level. Good settings for natural 
sounding, yet compressed vocals, are a medium fast (25 – 50 
ms) attack and a medium-slow (100 ms – 1 sec) release. Releas-
ing too quickly sounds unnatural, while attacking too slowly 
misses the problem surges. Soft knee compression generally best 
matches vocal dynamics. Adjust the ratio to match the dynamics 
of the singer, with 2:1 being a good starting point.
Tips and Tricks
0 
0 
6 
3 
12
24
dB 
-20 
-10 
0 
-40 
-30 
+20 
+10 
-20 
-10 
0 
-40 
-30 
+22 
+10 
ms ms 
dBu 
dBu 
dB Hz oct 
Headroom 
dB n:1 
10 
2 
1.5  5  -6  +6 
1 
500 
100 
50  250 
25 
10 
2 
1  5 
0.5 
20k 
640 
125 
3.15k 
20 
500 
125  1 s 
2 s 50 
25 
+12 -12 
+12 -12 
SIDE-CHAIN 
RELEASE ATTACK  KNEE 
GAIN 
FREQUENCY BANDWIDTH 
LIMIT THRESHOLD 
RATIO  GAIN 
COMP THRESHOLD 
Auto 
Auto 
Soft Hard 
Listen Dynamic
EQ
Comp 
LIMIT 
BYPASS 
ACTIVE 
PEQ 










