Manual

Manual-2
FRONT PANEL DESCRIPTION
1. MICROPHONE LEVEL control: Adjusts the level for the paging microphone. The initial level is set by the MIC TRIM on
the rear panel so that this control can have the greatest range without distortion or feedback.
2. MICROPHONE DUCKER SENSITIVITY control: Sets the sensitivity at which the microphone signal ducks the program
material for paging purposes. If the ambient background noise level is high this control should be set lower to prevent false
triggers. A microphone with a switch is recommended.
3. PHONE/LINE LEVEL control: Sets the level for the phone system paging or voice line input.
4. PHONE/LINE DUCKER SENSITIVITY control: Sets the sensitivity at which the phone/line signal ducks the program
material for paging purposes. If the ambient background noise level is high this control should be set lower to prevent false
triggers.
5. IN USE LEDS: Indicate the source of the page. Also useful in determining why a pager is locked out due to the priority
page lockout feature. (See PAGING PRIORITY INTERNAL JUMPER OPTION described on page Manual-4.)
6. Front panel ZONE ASSIGN switch: Selects which zone the rear panel selected paging input will be routed to and activate
program ducking. (For more information see the REMOTE ZONE ASSIGN INPUT JACK section on page Manual-4.)
7. PROGRAM INPUT LEVEL controls: Adjust the relative levels of each of the four program inputs.
8. OVERLOAD LEDS: Indicate overload for the post-EQ, pre-zone signals.
9. PROGRAM SELECT rotary switch: Selects line inputs 1, 2, 3 or the priority/line 4 Input for each zone.
10. ZONE LEVEL control: Independently controls the volume in zone 1 and zone 2.
11. REMOTE CONTROL switch: Disables the front panel PROGRAM SELECT and ZONE LEVEL controls for each zone.
This alsoenables the SOURCE & LEVEL REMOTE jacks on the rear panel for remote control of these functions using the
optional R2 remote control.
12. ZONE 1 stereo graphic equalizer: Adjusts the frequency contour for the stereo zone 1 outputs (±12 dB). When zone 1 is
used in a dual mono mode, both channels receive the same EQ.
13. ZONE 2 mono graphic equalizer: Adjusts the frequency contour for the mono zone 2 output (±12 dB).
14. POWER indicator: Illuminates a warm yellow glow when the CP 62 is connected to an appropriate power source.