Manual

Manual-6
CP R2 Source & Level Remote
Control
Table 1 shows the flexibility of configuring the R2. The
R2 controls operate the same as the PROGRAM SELECT and
ZONE LEVEL controls on the front of the CP 62, when
enabled by the front panel REMOTE CONTROL button.
ZONE 1 STEREO MODE
Locate and set the switch in the R2 to STEREO, as shown
in Figure 1a.
ZONE 1 MONO MODE
This delivers a total of three mono zones from the CP 62.
Zone 1a and 1b use the same source with independent
LEVEL controls. To separate Zone 1 into 1a and 1b, use two
R2 remotes connected to Zone 1. Plug a cable from the MAIN
jack of the first R2 into the ZONE 1 REMOTE jack on the
back of the CP 62 and set the first R2s slide switch to DUAL
MONO, as shown in Figure 1b. Plug a cable from the MAIN
jack of the second R2 into the AUX jack on the first R2. A
third R2 plugged into the CP 62 ZONE 2 REMOTE jack
gives control over the third mono zone, operated as Zone 2.
Figure 1a. Figure 1b.
Table 1. R2 Installation Options
Desired Configuration Remote Functions Zone 1 Mode R2 Connections
1 Stereo Zone (Zone 1) SELECT & stereo LEVEL STEREO CP 62 ZONE 1 SOURCE & LEVEL jack
1 Mono Zone (Zone 2) SELECT & mono LEVEL not applicable CP 62 ZONE 2 SOURCE & LEVEL jack
Both of the above both as above STEREO 2 R2 units both as above
3 Mono Zones (Zones 1a, 1b, & 2)
Zone 1a and 1b use the same
Source Selection
Independent mono LEVEL
for Zone 1a, 1b, and 2.
SELECT for Zone 1a & 1b.
SELECT for Zone 2.
MONO Use 3 R2s. Zone 1a - first R2’s MAIN to the CP 62
ZONE 1 SOURCE & LEVEL jack. Zone 1b - second
R2’s MAIN to the first R2’s AUX jack. Zone 2 - third
R2 to CP 62 ZONE 2 SOURCE & LEVEL jack.
DECORA is a registered trademark of Leviton Manufacturing Co., Inc.