Manual

Manual-3
CP 64 REAR PANEL
 Chassis Ground Screw provides a convenient earth (technical) ground connection point. e CP 64 does not ground the chassis
through the power cord. It is important that the unit be grounded.
 POWER jack accepts the cable from a Rane RS 1 remote power supply (included). is is not a telephone jack. Use of a supply not
approved by Rane may damage your unit and void the warranty.
 REMOTES ports provides the wiring interface for two optional ZR 1 wired remotes. Each ZR 1 remote provides remote control of
Zone Level and Zone Program Select functions. Refer to page Manual-6 for details.
 ZONE OUTPUT ports feature balanced, cross-coupled line drivers with Euroblock connectors. Zone 1 is stereo. Zone 2 is mono.
 ZONE LIMIT threshold controls set the maximum output level for each Zone. ese circuits are true voltage limiters with a ratio
of 15:1. e threshold range is -20 dBu to +20 dBu
 EXPAND OUTPUT ports feature balanced, cross-coupled line drivers with Euroblock connectors. Zone Expand Outputs are
mono.
 EXPAND switches assign Page-only, Program-only or Zone1 or Zone 2 as the source for each Expand Output.
 PROGRAM PRIORITY ASSIGN switch determines in which Zone(s) the automatic priority override is enabled. Off (none),
Zone 1, Zone 2 or Both are the possible settings. If you do not intend to use the Priority Input as an automatic override Input, do
not assign it with this switch. Use the Zone PROGRAM SELECT switch on the front panel.
 Four PROGRAM INPUTS are provided. ree are non-priority Inputs. e fourth is a Program PRIORITY Input. When signal
is present at the PRIORITY Input, it is automatically selected as the Input source in the Zone(s) it is assigned with the Program
PRIORITY ASSIGN switch.
 RMT ZONE ASSIGN port provides the interface for the PR 2 wired remote. e PR 2 remote is used for Zone assignment of Page
Inputs. Refer to page Manual-6 for details.
 PAGING INPUTS DETECT THRESHOLD sets the Page signal level required to gate a Page on and light the ACTIVE indica-
tor. e range is -∞ (on) to +4 dBu.
 e PAGING INPUTS OL indicator lights when either of the Page Input preamplifiers comes within 3 dB of clipping.
 PAGE 1 and PAGE 2 INPUT TRIM controls adjust Page Input preamplifier gain to match the microphone/source in use, not to
set the page level in the Zones. e range is 30 dB to 60 dB.
 PAGE 1 and PAGE 2 INPUT Euroblock connector provides access to the two balanced instrumentation Paging amplifiers. ese
Inputs may be operated balanced or unbalanced.
 PAGE 1 and PAGE 2 INPUT MIC/LINE switches select 30 dB Input Pads when set to LINE. Phantom Power is disabled when
LINE is selected.
2
3
5
7
8
9
10
11
12
1
4
6
14
13
15
PRIORITY
ASSIGN
OFF
D1 D0 CLASS 2 EQUIPMENT
750mA
Vr
2Vc2 D1 D0 Vc1
LIMIT
– +
LIMIT
+Vr1
– + +
– –
+
PROGRAM
– +
PROGRAM
–
+
– +
+
– –
+
– +–
ZONE 2
POWER
ZONE 1 ZONE 2 OUT ZONE 1 OUT
+8
20
RIGHT LEFT
EXPAND 2 OUT EXPAND 1 OUT
PAGEZONE
2
ZONE
1
PAGE
+60 +30+30 +60
MIC LINE MIC LINE
BOTH
PRIORITY 3 2
Z2Z2 Z1 Z1
1
RANE CORP.
MADE IN U.S.A.
OL
+
– – +
+
– – +
Z1
Z2
DETECT THRESHOLDRMT ZONE ASSIGN
PAGE 2 PAGE 1
PAGE 2 PAGE 1
PAGE 1PAGE 2
TRIM
TRIM
CP 64
– +
+8
20
PAGING INPUTS
R
L
R
L
REMOTES OUTPUTS
D1 D0
MIN
D1 D0
MIN
PROGRAM INPUTS
ACN 001 345 482