Owner's Manual
Table Of Contents
RANE]
Installation
DRZH can be mounted in a standard 1-gang US electrical box:
1.
Run
a shielded Ethernet cable (Cat5e or Cat6) from the audio
processing unit
to
the electrical box, and then connect
it
to
the RJ45
port
on DRZH's rear panel.
DRZH
can be located
up
to 300 meters
(984 feet) from the processing unit.
2.
Use the included screws to secure the
DRZH
rear housing
to
the
electrical box and wall.
Note: A minimum
114•
diameter by
1•
depth (6.35 x 25.4 mm) pilot
hole is required for the included
wall
anchors.
3. Make sure the
knob
has been removed, then place the faceplate
over the
DRZH
housing and reattach the knob.
1-gang
US
Electrical Box
Screws
DRZH
Rear
Housing
9
......
0 Knob
DRZH
Faceplate
5