Ready Exp dB Headroom 24 12 Load Comp Fault Limit 6 1 3 dB Headroom 24 12 6 3 Exp Comp Limit 2 Ready Load Fault dB Headroom 24 12 6 3 Exp Comp Limit 3 Ready Load Fault dB Headroom 24 12 6 3 Exp Comp Limit 4 Ready Load Fault ON DIGITAL AMPLIFIER MA 4 MULTICHANNEL AMPLIFIER MA 4
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with manufacturer’s instructions. 8. Do not install near any heat sources such as radiators, registers, stoves, or other apparatus (including amplifiers) that produce heat. 9.
INSTRUCTIONS DE SÉCURITÉ 1. Lisez ces instructions. 2. Gardez précieusement ces instructions. 3. Respectez les avertissements. 4. Suivez toutes les instructions. 5. Ne pas utiliser près d’une source d’eau. 6. Ne nettoyer qu’avec un chiffon doux. 7. N’obstruer aucune évacuation d’air. Effectuez l’installation en suivant les instructions du fabricant. 8. Ne pas disposer près d’une source de chaleur, c-à-d tout appareil produisant de la chaleur sans exception. 9. Ne pas modifier le cordon d’alimentation.
OPERATORS MANUAL MA 4 MULTICHANNEL AMPLIFIER 1 2 3 4 ON 3 Limit Fault 3 Limit Fault 3 Limit Fault 3 Limit Fault 6 Comp Load 6 Comp Load 6 Comp Load 6 Comp Load Exp Ready Exp Ready Exp Ready Exp Ready 12 12 12 24 24 dB Headroom 12 24 dB Headroom MA 4 DIGITAL AMPLIFIER 24 dB Headroom dB Headroom Quick Start Basic MA 4 operation is straightforward: 1. The universal switching power supply works with 100 to 240 VAC, 50/60 Hz. 2.
Description & Operation • Each channel delivers 100 watts of power into a 4 or 8Ω load (constant power). º Average load impedance is estimated, then used to set the limiter to confine the maximum average power to 100 watts. • Universal voltage, power-factor-corrected power supply (see figure on data sheet). º Switch-mode power supply operates 100 to 240 VAC, 50 Hz or 60 Hz. º Under- and over-voltage protection with inrush current management. º The power supply features an IEC appliance inlet.
• Individual FAULT FLAG ports are provided for each channel. OUTPUTS MA 4 COMMERCIAL AUDIO MADE IN U.S.A. Class 2 Wiring º When a fault is detected channels and the appropriate front EQUIPMENT 24TJ affected are not enabled, RANE CORP. on power up, the channel or INT EXT INT EXT INT EXT INT EXT 2 1 panel fault indicators are lit. A detected fault is re-tested every 104seconds. 3 LOAD LOAD LOAD OFF.
Advanced Applications Remote Turn-on To operate an amplifier channel in low power standby with remote turn-on, set its rear panel switch to SLAVE. External +5 volts connected to the FAULT FLAG holds the amplifier in standby. Floating the FAULT FLAG or connecting it to ground turns the channel on. MADE IN U.S.A. RANE CORP.
